PIC12LCR509A_00 View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
PIC12LCR509A_00 Datasheet PDF : 6 Pages
| |||
PIC12C508A/509A
13.3 DC CHARACTERISTICS:
PIC12C508A/509A (Commercial, Industrial, Extended)
PIC12CE518/519 (Commercial, Industrial, Extended)
PIC12CR509A (Commercial, Industrial, Extended)
DC CHARACTERISTICS
Param
No.
Characteristic
Standard Operating Conditions (unless otherwise specified)
Operating temperature 0°C ≤ TA ≤ +70°C (commercial)
–40°C ≤ TA ≤ +85°C (industrial)
–40°C ≤ TA ≤ +125°C (extended)
Operating voltage VDD range as described in DC spec Section 13.1 and Section 13.2.
Sym Min Typ† Max Units
Conditions
Input High Voltage
I/O ports
VIH
-
D040
with TTL buffer
2.0V
-
VDD
V 4.5V ≤ VDD ≤ 5.5V
D040A
0.25VDD + -
VDD
V otherwise
0.8V
D070 GPIO weak pull-up current (Note 4) IPUR
30
250 400
µA VDD = 5V, VPIN = VSS
Input Leakage Current (Notes 2, 3)
IIL
D061 GP3/MCLR (Note 5)
8
130 250 µA Vss ≤ VPIN ≤ VDD
D061A GP3/MCLR (Note 6)
-
-
+5
µA Vss ≤ VPIN ≤ VDD
†
Note 1:
2:
3:
4:
5:
6:
Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only and are not tested.
In EXTRC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC12C5XX be driven with external clock in RC mode.
The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels represent nor-
mal operating conditions. Higher leakage current may be measured at different input voltages.
Negative current is defined as coming out of the pin.
Does not include GP3. For GP3 see parameters D0061 and D0061A.
This spec. applies to GP3/MCLR configured as external MCLR and GP3/MCLR configured as input with internal pull-up enabled.
This spec. applies when GP3/MCLR is configured as an input with pull-up disabled. The leakage current of the MCLR circuit
is higher than the standard I/O logic.
2000 Microchip Technology Inc.
DS80024B-page 3
Share Link: 