ADT6402SRJZ-RL7(RevC) View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

ADT6402SRJZ-RL7
(Rev.:RevC)

Low Cost, 2.7 V to 5.5 V, Pin-Selectable Temperature Switches in SOT-23

Analog Devices 

ADT6401/ADT6402

ABSOLUTE MAXIMUM RATINGS

Table 2.

Parameter

VCC to GND

S0, S1, S2 Input Voltage to GND

Open-Drain Output Voltage to GND

Push-Pull Output Voltage to GND

Input Current on All Pins

Output Current on All Pins

ESD rating (HBM)

Operating Temperature Range

Storage Temperature Range

Maximum Junction Temperature, TJMAX

6-Lead SOT-23 (RJ-6)

Power Dissipation1

Thermal Impedance3

θJA, Junction-to-Ambient (Still Air)

IR Reflow Soldering (RoHS-Compliant

Package)

Peak Temperature

Time at Peak Temperature

Ramp-Up Rate

Ramp-Down Rate

Time 25°C to Peak Temperature

Rating

−0.3 V to +7 V

−0.3 V to VCC + 0.3 V

−0.3 V to +7 V

−0.3 V to VCC + 0.3 V

20 mA

20 mA

1.5 kV

−55°C to +125°C

−65°C to +160°C

150.7°C

WMAX = (TJMAX − TA2)/θJA

229.6°C/W

260°C (+0°C)

20 sec to 40 sec

3°C/sec maximum

−6°C/sec maximum

8 minute maximum

1 Values relate to package being used on a standard 2-layer PCB, which gives a

worst-case θJA. Refer to Figure 2 for a plot of maximum power dissipation vs.

ambient temperature (TA).

2 TA = ambient temperature.

3 Junction-to-case resistance is applicable to components featuring a

preferential flow direction, for example, components mounted on a

heat sink. Junction-to-ambient resistance is more useful for air-cooled,

PCB-mounted components.

Data Sheet

Stresses above those listed under Absolute Maximum Ratings

may cause permanent damage to the device. This is a stress

rating only; functional operation of the device at these or any

other conditions above those indicated in the operational

section of this specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect

device reliability.

0.9

0.8

0.7

0.6

0.5

0.4

0.3

0.2

0.1

SOT-23 PD @ 125°C = 0.107W

0

–55 –40 –20 0 20 40 60 80 100 120

–50 –30 –10 10 30 50 70 90 110 125

TEMPERATURE (°C)

Figure 2. SOT-23 Maximum Power Dissipation vs. Temperature

ESD CAUTION

Rev. C | Page 4 of 12

Share Link: