JS28F128P30BF65 View Datasheet(PDF) - Numonyx -> Micron
Part Name
Description
Manufacturer
JS28F128P30BF65
Numonyx -> Micron
JS28F128P30BF65 Datasheet PDF : 90 Pages
| |||
P30-65nm SBC
Figure 9: Block Locking State Diagram
P G M /E R A S E
ALLOW ED
P G M /E R A S E
PREVENTED
[000 ]
LK/
D0h
L K /2F h
LK/
01h
[001 ]
LK/
2Fh
P o w er-U p /
R eset D efau lt
W P # = V IL = 0
V irtu al lo ck-
dow n
[0 1 0 ]
[011 ]
Lo cked -do w n
W P # = V IH = 1
[110 ]
[100 ]
W P # toggle
LK/
D 0h
LK/
D0h
Any Lock
com m ands
W P # to g g le
LK/
01h or 2Fh
LK/
2Fh
LK/
01h
[111 ]
L o cked -d o w n
is d isab led b y
W P # = V IH
LK/
2Fh
P ow er-U p/
R eset D efau lt
[101 ]
Note: LK: Lock Setup Command, 60h; LK/D0h: Unlock Command; LK/01h: Lock Command; LK/2Fh: Lock-Down Command.
10.1.5
Block Locking During Suspend
Block lock and unlock changes can be performed during an erase suspend. To change
block locking during an erase operation, first issue the Erase Suspend command.
Monitor the Status Register until SR.7 and SR.6 are set, indicating the device is
suspended and ready to accept another command.
Next, write the desired lock command sequence to a block, which changes the lock
state of that block. After completing block lock or unlock operations, resume the erase
operation using the Erase Resume command.
Note:
A Lock Block Setup command followed by any command other than Lock Block, Unlock
Block, or Lock-Down Block produces a command sequence error and set Status
Register bits SR.4 and SR.5. If a command sequence error occurs during an erase
suspend, SR.4 and SR.5 remains set, even after the erase operation is resumed. Unless
the Status Register is cleared using the Clear Status Register command before
resuming the erase operation, possible erase errors may be masked by the command
sequence error.
If a block is locked or locked-down during an erase suspend of the same block, the lock
status bits change immediately. However, the erase operation completes when it is
resumed. Block lock operations cannot occur during a program suspend. See Appendix
A, “Write State Machine†on page 83, which shows valid commands during an erase
suspend.
Datasheet
32
Apr 2010
Order Number: 208033-02
|
|
Share Link: