S-1167 View Datasheet(PDF) - Seiko Instruments Inc

Part Name

Description

Manufacturer

S-1167

ULTRA LOW CURRENT CONSUMPTION, HIGH RIPPLE REJECTION AND LOW DROPOUT CMOS VOLTAGE REGULATOR

Seiko Instruments Inc 

ULTRA LOW CURRENT CONSUMPTION, HIGH RIPPLE REJECTION AND LOW DROPOUT CMOS VOLTAGE REGULATOR

Rev.2.3_00

S-1167 Series

„ Precautions

• Wiring patterns for the VIN pin, VOUT pin and GND pin should be designed so that the impedance is low. When

mounting an output capacitor between the VOUT pin and VSS pin (CL) and a capacitor for stabilizing the input between

VIN pin and VSS pin (CIN), the distance from the capacitors to these pins should be as short as possible.

• Note that the output voltage may increase when a series regulator is used at low load current (10 µA or less).

• Note that the output voltage may increase due to driver leakage when a series regulator is used at high temperatures.

• Generally a series regulator may cause oscillation, depending on the selection of external parts. The following

conditions are recommended for this IC. However, be sure to perform sufficient evaluation under the actual usage

conditions for selection, including evaluation of temperature characteristics.

Input capacitor (CIN) : 1.0 µF or more

Output capacitor (CL) : 1.0 µF or more

Equivalent series resistance (RESR) : 1.0 Ω or less

• The voltage regulator may oscillate when the impedance of the power supply is high and the input capacitor is small or

an input capacitor is not connected.

• It is important to sufficiently evaluate the output voltage fluctuation due to the power supply fluctuation and load

fluctuation characteristics in the actual equipment.

• If the power supply suddenly increases sharply, a momentary overshoot may be output. It is therefore important to

sufficiently evaluate the output voltage at power application in the actual equipment.

• The application conditions for the input voltage, output voltage, and load current should not exceed the package power

dissipation.

• Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in electrostatic

protection circuit.

• In determining the output current, attention should be paid to the output current value specified in Table 6 in the “„

Electrical Characteristics” and footnote *5 of the table.

• SII claims no responsibility for any disputes arising out of or in connection with any infringement by products including

this IC of patents owned by a third party.

Seiko Instruments Inc.

15

Share Link: