MAX6412 View Datasheet(PDF) - Maxim Integrated
Part Name
Description
Manufacturer
MAX6412 Datasheet PDF : 12 Pages
| |||
MAX6412–MAX6420
Low-Power, Single/Dual-Voltage μP Reset Circuits
with Capacitor-Adjustable Reset Timeout Delay
VMON_TH
VCC
MAX6420
ONLY
VCC
LASER-TRIMMED
RESISTORS
RL
RESET
(RESET)
RESET
CIRCUITRY
1.26V
µP
R1
R2
CSRT
RESET IN
GND
SRT
MAX6418
MAX6419
MAX6420
Figure 4. MAX6418/MAX6419/MAX6420 Monitoring Two Voltages
Dual-Voltage Monitoring
(MAX6418/MAX6419/MAX6420)
The MAX6418/MAX6419/MAX6420 contain both factory-
trimmed threshold voltages and an adjustable reset
threshold input, allowing the monitoring of two voltages,
VCC and VMON_TH (see Figure 4). Reset is asserted
when either of the voltages falls below its respective
threshold voltage.
Application Information
Selecting a Reset Capacitor
The reset timeout period is adjustable to accommodate a
variety of μP applications. Adjust the reset timeout period
(tRP) by connecting a capacitor (CSRT) between SRT and
ground. Calculate the reset timeout capacitor as follows:
CSRT = (tRP - 275μs) / (2.71 x 106)
where tRP is in seconds and CSRT is in Farads
The reset delay time is set by a current/capacitor-con-
trolled ramp compared to an internal 0.65V reference. An
internal 240nA ramp current source charges the external
capacitor. The charge to the capacitor is cleared when a
reset condition is detected. Once the reset condition is
removed, the voltage on the capacitor ramps according to
the formula: dV/dt = I/C. The CSRT capacitor must ramp to
0.65V to deassert the reset. CSRT must be a low-leakage
(<10nA) type capacitor, ceramic is recommended.
Operating as a Voltage Detector
The MAX6412–MAX6420 can be operated in a voltage
detector mode by leaving SRT unconnected. The reset
delay times for VCC rising above or falling below the
threshold are not significantly different. The reset output
is deasserted smoothly without false pulses.
www.maximintegrated.com
Maxim Integrated │ 7
|
|
Share Link: 