AD9048TQ View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

AD9048TQ

Monolithic 8-Bit Video A/D Converter

Analog Devices 

AD9048

THEORY OF OPERATION

Refer to the Functional Block Diagram of the AD9048. The

AD9048 comprises three functional sections: a comparator

array, encoding logic and output latches.

Within the array, the analog input signal to be digitized is com-

pared with 255 reference voltages. The outputs of all compara-

tors whose references are below the input signal level will be

high; outputs whose references are above that level will be low.

The n-of-255 code that results from this comparison is applied

to the encoding logic where it is converted into binary coding.

When it is inverted with dc signals applied to the NLINV and/or

NMINV pins, it becomes twos complement.

After encoding, the signal is applied to the output latch circuits

where it is held constant between updates controlled by the

application of CONVERT pulses.

The AD9048 uses strobed latching comparators in which com-

parator outputs are either high or low, as dictated by the analog

input level. Data appearing at the output pins have a pipeline

delay of one encode cycle.

Input signal levels between the references applied to RT (Pin 18)

and RB (Pin 26) will appear at the output as binary numbers

between 0 and 255, inclusive. Signals outside that range will

show up as either full-scale positive or full-scale negative out-

puts. No damage will occur to the AD9048 as long as the input

is within the voltage range of VEE to +0.5 V.

The significantly reduced input capacitance of the AD9048

lowers the drive requirements of the input buffer/amplifier and

also induces much smaller phase shift in the analog input signal.

Applications that depend on controlled phase shift at the con-

verter input can benefit from using the AD9048 because of its

inherently lower phase shift.

The CONVERT, analog input and digital output circuits are

shown in Figure 1.

System timing, which provides details on delays through the

AD9048 as well as the relationships of various timing events, is

shown in Figure 2.

Dynamic performance of the AD9048, i.e., typical signal-to-

noise ratio, is illustrated in Figures 3 and 4.

Figure 1. Input/Output Circuits

Figure 2. Timing Diagram

–6–

REV. C

Share Link: