GRM219C80J475ME32 View Datasheet(PDF) - Murata Manufacturing
Part Name
Description
Manufacturer
GRM219C80J475ME32 Datasheet PDF : 30 Pages
| |||
(2) Example of a Disc Separator
An outline of a disc separator is shown as follows. As shown in the Principle of Operation, the top blade and bottom blade are aligned with the V-grooves on the printed circuit board to separate the board.
In the following case, board deflection stress will be applied and cause cracks in the capacitors.
(1) When the adjustment of the top and bottom blades are misaligned, such as deviating in the top-bottom, left-right or front-rear directions
(2) The angle of the V groove is too low, depth of the V groove is too shallow, or the V groove is misaligned top-bottom
IF V groove is too deep, it is possible to brake when you handle and carry it. Carefully design depth of the V groove with consideration about strength of material of the printed circuit board.
[ Outline of Machine ]
Top Blade
[ Principle of Operation ]
Top Blade
[ Cross-section Diagram ]
Printed Circuit Board
Printed Circuit Board
V-groove
Bottom Blade
V-groove
[ Disc Separator ]
Recommended
Top Blade
Top-bottom Misalignment
Top Blade
Not recommended
Left-right Misalignment
Top Blade
Front-rear Misalignment
Top Blade
Bottom Blade
Bottom Blade
[ V-groove Design ]
Example of Recommended
V-groove Design
Left-right Misalignment
Bottom Blade
Bottom Blade
Not Recommended
Low-Angle
Depth too Shallow
Depth too Deep
(3) Example of Router Type Separator
The router type separator performs cutting by a router rotating at a high speed.
Since the board does not bend in the cutting process, stress on the board can be suppressed during board separation.
When attaching or removing boards to/from the router type separator, carefully handle the boards to prevent bending.
[ Outline Drawing ]
Router
GRM219C80J475ME32-01A
|
|
Share Link: 