24C32 View Datasheet(PDF) - Estek Electronics Co. Ltd

Part Name

Description

Manufacturer

24C32

Two-wire Serial EEPROM

Estek Electronics Co. Ltd 

¡Figure 3: Output Acknowledge

24C32 / 24C64

EE

1

SCL

DATA IN

DATA OUT

START

8

9

ACKNOWLEDGE

Device Addressing

The 32K and 64K EEPROM devices all require an 8-bit device address word following a start condition to enable the

chip for a read or write operation (see to Figure 4 on page 7).

The device address word consists of a mandatory "1", "0" sequence for the first four most significant bits as shown.

This is common to all the Serial EEPROM devices.

The next 3 bits are the A2, A1 and A0 device address bits for the 32K/64K EEPROM. These 3 bits must compare to

their corresponding hardwired input pins.

The eighth bit of the device address is the read/write operation select bit. A read operation is initiated if this bit is high

and a write operation is initiated if this bit is low.

Upon a compare of the device address, the EEPROM will output a "0". If a compare is not made, the chip will return to a

standby state.

BEIJING ESTEK ELECTRONICS CO.,LTD

5

Share Link: