X9312 View Datasheet(PDF) - Xicor -> Intersil
Part Name
Description
Manufacturer
X9312 Datasheet PDF : 9 Pages
| |||
X9312
PIN DESCRIPTIONS
VH and VL
The high (VH) and low (VL) terminals of the X9312
are equivalent to the fixed terminals of a mechanical
potentiometer. The minimum voltage is 0V and the
maximum is +15V. It should be noted that the
terminology of VL and VH references the relative position
of the terminal in relation to wiper movement direction
selected by the U/D input and not the voltage potential on
the terminal.
VW
Vw is the wiper terminal, equivalent to the movable
terminal of a mechanical potentiometer. The position
of the wiper within the array is determined by the
control inputs. The wiper terminal series resistance is
typically 40Ω.
Up/Down (U/D)
The U/D input controls the direction of the wiper move-
ment and whether the counter is incremented or
decremented.
Increment (INC)
The INC input is negative-edge triggered. Toggling INC
will move the wiper and either increment or decrement
the counter in the direction indicated by the logic level on
the U/D input.
Chip Select (CS)
The device is selected when the CS input is LOW. The
current counter value is stored in nonvolatile memory
when CS is returned HIGH while the INC input is also
HIGH. After the store operation is complete the X9312
will be placed in the low power standby mode until the
device is selected once again.
PIN CONFIGURATION
INC
U/D
VH
VSS
DIP/SOIC
1
8
2
7
X9312
3
6
4
5
VCC
CS
VL
VW
3863 FHD F02.1
PIN NAMES
Symbol
VH
VW
VL
VSS
VCC
U/D
INC
CS
Description
High Terminal
Wiper Terminal
Low Terminal
Ground
Supply Voltage
Up/Down Input
Increment Input
Chip Select Input
3865 PGM T01
2
|
|
Share Link: 