STM32F100RC View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F100RC

High-density value line, advanced ARM-based 32-bit MCU with 256 to 512 KB Flash, 16 timers, ADC, DAC & 11 comm interfaces

STMicroelectronics 

STM32F100xC STM32F100xD

STM32F100xE

High-density value line, advanced ARM-based 32-bit MCU with

256 to 512 KB Flash, 16 timers, ADC, DAC & 11 comm interfaces

Datasheet −production data

Features

■ Core: ARM 32-bit Cortex™-M3 CPU

– 24 MHz maximum frequency, 1.25 DMIPS

/MHz (Dhrystone 2.1) performance

– Single-cycle multiplication and hardware

division

■ Memories

– 256 to 512 Kbytes of Flash memory

– 24 to 32 Kbytes of SRAM

– Flexible static memory controller with 4

Chip Selects. Supports SRAM, PSRAM

and NOR memories

– LCD parallel interface, 8080/6800 modes

■ Clock, reset and supply management

– 2.0 to 3.6 V application supply and I/Os

– POR, PDR and programmable voltage

detector (PVD)

– 4-to-24 MHz crystal oscillator

– Internal 8 MHz factory-trimmed RC

– Internal 40 kHz RC

– PLL for CPU clock

– 32 kHz oscillator for RTC with calibration

■ Low power

– Sleep, Stop and Standby modes

– VBAT supply for RTC and backup registers

■ Serial wire debug (SWD) and JTAG I/F

■ DMA

– 12-channel DMA controller

– Peripherals supported: timers, ADC, SPIs,

I2Cs, USARTs and DACs

■ 1 × 12-bit, 1.2 µs A/D converter (up to 16 ch.)

– Conversion range: 0 to 3.6 V

– Temperature sensor

■ 2 × 12-bit D/A converters

■ Up to 112 fast I/O ports

– 51/80/112 I/Os, all mappable on 16

external interrupt vectors and almost all

5 V-tolerant

LQFP144

20 × 20 mm

LQFP100

14 × 14 mm

LQFP64

10 × 10 mm

■ Up to 16 timers

– Up to seven 16-bit timers, each with up to 4

IC/OC/PWM or pulse counter

– One 16-bit, 6-channel advanced-control

timer: up to 6 channels for PWM output,

dead time generation and emergency stop

– One 16-bit timer, with 2 IC/OC, 1

OCN/PWM, dead-time generation and

emergency stop

– Two 16-bit timers, each with

IC/OC/OCN/PWM, dead-time generation

and emergency stop

– Two watchdog timers

– SysTick timer: 24-bit downcounter

– Two 16-bit basic timers to drive the DAC

■ Up to 11 communications interfaces

– Up to two I2C interfaces (SMBus/PMBus)

– Up to 3 USARTs (ISO 7816 interface, LIN,

IrDA capability, modem control)

– Up to 2 UARTs

– Up to 3 SPIs (12 Mbit/s)

– Consumer electronics control (CEC) I/F

■ CRC calculation unit, 96-bit unique ID

Table 1. Device summary

Reference

Part number

STM32F100xC

STM32F100xD

STM32F100xE

STM32F100RC, STM32F100VC,

STM32F100ZC

STM32F100RD, STM32F100VD,

STM32F100ZD

STM32F100RE, STM32F100VE,

STM32F100ZE

September 2012

This is information on a product in full production.

Doc ID 15081 Rev 7

1/98

www.st.com

1

Share Link: