ACE24C128B View Datasheet(PDF) - ACE Technology Co., LTD.

Part Name

Description

Manufacturer

ACE24C128B

Two-wire Serial EEPROM

ACE Technology Co., LTD. 

ACE24C128B/256B/512B

Two-wire Serial EEPROM

Figure 2: Start and Stop Definition

Figure 3: Output Acknowledge

Device Addressing

The 128K/256K/512K EEPROM devices all require an 8-bit device address word following a start

condition to enable the chip for a read or write operation (see to Figure 4 on page 7).

The device address word consists of a mandatory "1", "0" sequence for the first four most significant

bits as shown. This is common to all the Serial EEPROM devices.

The 128K/256K/512K EEPROM uses A2, A1 and A0 device address bits to allow as much as eight

devices on the same bus. These 3 bits must be compared to their corresonding hardwired input pins.

The A2, A1 and A0 pins use an internal proprietary circuit that biases them to a logic low condition if the

pins are allowed to float.

VER 1.4 6

Share Link: