Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

FM25D04C-1ACA3T Просмотр технического описания (PDF) - FIDELIX

Номер в каталогеКомпоненты Описаниепроизводитель
FM25D04C-1ACA3T 32M-BIT Serial Flash Memory with 4KB Sectors, Dual and QuadI/O SPI FIDELIX
FIDELIX FIDELIX
FM25D04C-1ACA3T Datasheet PDF : 61 Pages
First Prev 31 32 33 34 35 36 37 38 39 40 Next Last
FM25Q32
11.2.17 32KB Block Erase (52h)
The Block Erase instruction sets all memory within a specified block (32k-bytes) to the erased state
of all 1s (FFh). A Write Enable instruction must be executed before the device will accept the Block
Erase Instruction (Status Register bit WEL must equal 1). The instruction is initiated by driving the
/CS pin low and shifting the instruction code “52h” followed a 24-bit block address (A23-A0). The
Block Erase instruction sequence is shown in figure 17.
The /CS pin must be driven high after the eighth bit of the last byte has been latched. If this is not
done the Block Erase instruction will not be executed. After /CS is driven high, the self-timed Block
Erase instruction will commence for a time duration of tBE1 (See AC Characteristics). While the
Block Erase cycle is in progress, the Read Status Register instruction may still be accessed for
checking the status of the BUSY bit. The BUSY bit is a 1 during the Block Erase cycle and
becomes a 0 when the cycle is finished and the device is ready to accept other instructions again.
After the Sector Erase cycle has finished the Write Enable Latch (WEL) bit in Status Register is
cleared to 0.The Block Erase instruction will not be executed if the addressed page is protected by
the Block Protect (SEC, TB, BP2, BP1, and BP0) bits (see Status Register Memory Protection
table).
Figure 17. 32KB Block Erase Instruction Sequence Diagram
preliminary(Aug.18.2010) 33
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]