Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

FM25D04C-1ACB2R Просмотр технического описания (PDF) - FIDELIX

Номер в каталогеКомпоненты Описаниепроизводитель
FM25D04C-1ACB2R 32M-BIT Serial Flash Memory with 4KB Sectors, Dual and QuadI/O SPI FIDELIX
FIDELIX FIDELIX
FM25D04C-1ACB2R Datasheet PDF : 61 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
FM25Q32
11.2.11 Fast Read Dual I/O (BBh)
The Fast Read Dual I/O (BBh) instruction allows for improved random access while maintaining
two IO pins, IO0 and IO1. It is similar to the Fast Read Output (0Bh) instruction but with the
capability to input the Address bits (A23-0) two bits and output data two bits per clock. This
reduced instruction overhead may allow for code execution (XIP) directly from the Dual SPI in
some applications.
The Fast Read Dual I/O instruction can further reduce instruction overhead through setting the
Mode bits (M7-0) after the input Address bits (A23-0), as shown in figure 11a. The upper nibble of
the Mode (M7-4) controls the length of the next Fast Read Dual I/O instruction through the
instruction or exclusion of the first byte instruction code. The lower nibble bits of the Mode (M3-0)
are don’t care (“X”), However, the IO pins should be high-impedance prior to the falling edge of the
first data out clock.
If the Mode bits (M7-0) equal “Ax” hex, then the next Fast Dual I/O instruction (after /CS is raised
and then lowered) does not require the BBh instruction code, as shown in figure 11b. This reduces
the instruction sequence by eight clocks and allows the address to be immediately entered after
/CS is asserted low. If Mode bits (M7-0) are any value other “Ax” hex, the next instruction (after /CS
is raised and then lowered) requires the first byte instruction code, thus returning to normal
operation. A Mode Bit Reset instruction can be used to reset Mode Bits (M7-0) before issuing
normal instructions (See 11.2.25 for detailed descriptions).
Figure 11a. Fast Read Dual Input/Output Instruction Sequence Diagram (M7-0 = 0xh or NOT Axh)
preliminary(Aug.18.2010) 25
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]