!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
C85E.pdf
Sep.14,2018
Type SA: AC400V / RA: AC500V Specifications and Test Methods
Continued from the preceding page.
No.
Item
Specifications
17 Passive Flammability
The burning time should not exceed 30s.
The tissue paper should not ignite.
Test Method
The capacitor under test should be held in the flame in the
position that best promotes burning. Each specimen should
only be exposed once to the flame. Time of exposure to flame:
30s.
Length of flame : 12±1mm
Gas burner : Length 35mm min.
Inside Dia. 0.5±0.1mm
Outside Dia. 0.9mm max.
Gas
: Butane gas Purity 95% min.
Test Specimen
45°
Tissue
About 10mm Thick Board
Appearance
Capacitance
Change
No marked defect
Char.
B
E
SL
Capacitance Change
Within ±10%
Within ±20%
Within ± 5%
Char.
Specifications
D.F.
B, E
D.F.<=5.0%
SL
D.F.<=2.5%
The capacitor should be subjected to 5 temperature cycles,
then consecutively to 2 immersion cycles.
Step
1
2
3
4
<Temperature Cycle>
Temperature (ºC)
Time (min.)
-40+0/-3
30
Room temp.
3
125+3/-0
30
Room temp.
3
Cycle time: 500 cycles
I.R.
Temperature
18
and
Immersion
Cycle
3000MΩ min.
Dielectric
Strength
Per Item 6
Step
1
2
<Immersion Cycle>
Temperature (ºC)
65+5/-0
0±3
Time
Immersion
(min.)
Water
15
Clean
water
15
Salt
water
Cycle time: 2 cycles
Pre-treatment:
Capacitor should be stored at 125±2ºC for 1h, and apply the
AC2000V(r.m.s.) 60s (in case of Type RA, apply the
AC4000V(r.m.s.) 60s) then placed at room condition* for
24±2h. (Do not apply to SL char.)
Post-treatment:
Capacitor should be stored for 24±2h at room condition*.
* "Room condition" Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmosphere pressure: 86 to 106kPa
22