TEA1751(L)T View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

Manufacturer

TEA1751(L)T

HV start-up DCM/QR flyback controller with integrated DCM/QR PFC controller

NXP Semiconductors. 

NXP Semiconductors

TEA1751T; TEA1751LT

GreenChip III SMPS control IC

7.2.3 Frequency limitation

To optimize the transformer and minimize switching losses, the switching frequency is

limited to fsw(PFC)max. If the frequency for quasi-resonant operation is above the fsw(PFC)max

limit, the system switches over to discontinuous conduction mode. Also here, the PFC

MOSFET is only switched on at a minimum voltage across the switch (valley switching).

7.2.4 Mains voltage compensation (VINSENSE pin)

The mathematical equation for the transfer function of a power factor corrector contains

the square of the mains input voltage. In a typical application this results in a low

bandwidth for low mains input voltages, while at high mains input voltages the Mains

Harmonic Reduction (MHR) requirements may be hard to meet.

To compensate for the mains input voltage influence, the TEA1751(L)T contains a

correction circuit. Via the VINSENSE pin the average input voltage is measured and the

information is fed to an internal compensation circuit. With this compensation it is possible

to keep the regulation loop bandwidth constant over the full mains input range, yielding a

fast transient response on load steps, while still complying with class-D MHR

requirements.

In a typical application, the bandwidth of the regulation loop is set by a resistor and two

capacitors on the PFCCOMP pin.

7.2.5 Soft start-up (pin PFCSENSE)

To prevent audible transformer noise at start-up or during hiccup, the transformer peak

current, IDM, is increased slowly by the soft start function. This can be achieved by

inserting RSS1 and CSS1 between pin PFCSENSE and current sense resistor RSENSE1.

An internal current source charges the capacitor to VPFCSENSE = Istart(soft)PFC × RSS1. The

voltage is limited to Vstart(soft)PFC.

The start level and the time constant of the increasing primary current level can be

adjusted externally by changing the values of RSS1 and CSS1.

τsoftstart = 3 × RSS1 × CSS1

The charging current Istart(soft)PFC flows as long as the voltage on pin PFCSENSE is

below 0.5 V (typ). If the voltage on pin PFCSENSE exceeds 0.5 V, the soft start current

source starts limiting current Istart(soft)PFC. As soon as the PFC starts switching, the

Istart(soft)PFC current source is switched off; see Figure 5.

TEA1751T_LT_2

Product data sheet

Rev. 02 — 23 December 2009

© NXP B.V. 2009. All rights reserved.

9 of 29

Share Link: