DatasheetQ Logo
Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

PZTA42T1 View Datasheet(PDF) - ON Semiconductor

Part Name
Description
Manufacturer
PZTA42T1 Datasheet PDF : 8 Pages
1 2 3 4 5 6 7 8
PZTA42T1
INFORMATION FOR USING THE SOT-223 SURFACE MOUNT PACKAGE
MINIMUM RECOMMENDED FOOTPRINT FOR SURFACE MOUNTED APPLICATIONS
Surface mount board layout is a critical portion of the total
design. The footprint for the semiconductor packages must
be the correct size to insure proper solder connection
0.15
3.8
interface between the board and the package. With the
correct pad geometry, the packages will self align when
subjected to a solder reflow process.
0.079
2.0
0.079
2.0
0.091
2.3
0.091
2.3
0.248
6.3
0.059
1.5
0.059
1.5
0.059
1.5
SOT-223
inches
mm
SOT-223 POWER DISSIPATION
The power dissipation of the SOT-223 is a function of the
pad size. This can vary from the minimum pad size for
soldering to a pad size given for maximum power
dissipation. Power dissipation for a surface mount device is
determined by TJ(max), the maximum rated junction
temperature of the die, RθJA, the thermal resistance from the
device junction to ambient, and the operating temperature,
TA. Using the values provided on the data sheet for the
SOT-223 package, PD can be calculated as follows:
PD =
TJ(max) – TA
RθJA
The values for the equation are found in the maximum
ratings table on the data sheet. Substituting these values into
the equation for an ambient temperature TA of 25°C, one can
calculate the power dissipation of the device which in this
case is 1.5 watts.
PD = 150°C – 25°C = 1.5 watts
83.3°C/W
The 83.3°C/W for the SOT-223 package assumes the use
of the recommended footprint on a glass epoxy printed
circuit board to achieve a power dissipation of 1.5 watts.
There are other alternatives to achieving higher power
dissipation from the SOT-223 package. One is to increase
the area of the collector pad. By increasing the area of the
collector pad, the power dissipation can be increased.
Although the power dissipation can almost be doubled with
this method, area is taken up on the printed circuit board
which can defeat the purpose of using surface mount
technology. A graph of RθJA versus collector pad area is
shown in Figure 5.
160
Board Material = 0.0625
140
GĆ10/FRĆ4, 2 oz Copper
0.8 Watts
TA = 25°C
° 120
100
1.25 Watts*
1.5 Watts
*Mounted on the DPAK footprint
80
0.0
0.2
0.4
0.6
0.8
1.0
A, Area (square inches)
Figure 5. Thermal Resistance versus Collector
Pad Area for the SOT-223 Package (Typical)
Another alternative would be to use a ceramic substrate or
an aluminum core board such as Thermal Clad. Using a
board material such as Thermal Clad, an aluminum core
board, the power dissipation can be doubled using the same
footprint.
http://onsemi.com
4
 

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]