SA15CA View Datasheet(PDF) - MERITEK ELECTRONICS CORPORATION
Part Name
Description
Manufacturer
SA15CA Datasheet PDF : 4 Pages
| |||
Transient 9ROWDJH6XSSUHVVRUV
SA Series
FEATURES
Plastic Sackage.
Glass passivated chip junction.
500W Peak Pulse Power capability on 10/1000µs waveform.
Excellent clamping capability.
Repetition rate (duty cycle): 0.01%.
Low incremental surge resistance.
Fast response time: typically less than 1.0ps from 0 volt to BV for
8nidirectional and 5.0ns for %idirectional types.
Tiypical IR less than 1µA above 10V.
High temperature soldering guaranteed: 265°C/10 seconds/.375",
((9.5mm) lead length, 5lbs, (2.3kg) tension.
MERITEK
6
UL E223045
DO-204AC/DO-15
6
MMECHANICAL DATA
Case: JEDEC DO-15 Molded plastic over glass passivated junction.
M Terminals: Plated Axial leads, solderable per MIL-STD-750, Method 2026.
Polarity: Color band denotes cathode except Bidirectional.
Mounting Position: Any.
Weight: 0.015 ounce, 0.4 grams.
DEVICES FOR BIPOLAR APPLICATION
For %idirectional use C or CA suffix for type SA5.0 through type SA220 (e.g. SA5.0C, SA220CA);
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25ć ambient temperature unless otherwise specified.
RATING
SYMBOL
VALUE
UNIT
Peak Pulse Power Dissipation on 10/1000ȝs waveform. (Note1ˈFig.1)
PPPM
Peak Pulse Current on 10/1000ȝs waveform. (Note1Fig.3)
,PPM
Steady State Power Dissipation at TL =75ćˈLead length .375” (9.5mm).
( Fig.5)
PM(AV)
Peak Forward Surge Currentˈ8.3ms Single Half Sine-Wave Superimposed
on Rated Load. (JEDEC Method) (Note 2, Fig.6)
IFSM
Operating junction and Storage Temperature Range.
TJ , TSTG
Minimum 500 Watts
See Table
Amps
3.0
Watts
70
-55 to +175
Amps
ć
Notes: 1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25ć per Fig.2.
2. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minute maximum.
All specifications are subject to change without notice.
1
Rev 7
|
|
Share Link: 