SEMICONDUCTOR
DATA SHEET
P4SMAJ Series
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE 5.0 to 440 Volts 400 Watt Peak Power Pulse
SMA/DO-214AC Unit:inch(mm)
FEATURES
•For surface mounted applications in order to optimize board space.
•Low profile package
•Built-in strain relief
•Glass passivated junction
•Excellent clamping capability
•Low inductance
•Fast response time: typically less than 1.0 ps from 0 volts to BV min
•Typical IR less than 1µA above 10V
•High temperature soldering : 260°C/10 seconds at terminals.
•Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
•Pb free product at available : 99% Sn above meet RoHS
environment substance directive request
MECHANICAL DATA
•Case: JEDEC DO-214AC low profile molded plastic
•Terminals: Solder leads, solderable per MIL-STD-750, Method 2026
•Polarity: Indicated by cathode band except Bi-directional types.
•Standard Packageing: 12mm tape per(EIA-481)
•Quantify Per Reel : 1800 pcs / 7500 pcs
.062(1.60)
.047(1.20)
.114(2.90)
.098(2.50)
.181(4.60)
.157(4.00)
.096(2.44)
.078(2.00)
.060(1.52)
.030(0.76)
.008(.203 )
.002(.051)
.208(5.28)
.188(4.80)
.012(.305)
.006(.152)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
RATING
SYMBOL
Peak Power Dissipation on 10/1000us waveform (Note1.2 , Fig.1) Ppp
VALUE
400
Peak Forward Surge Current, 8.3ms single half sine - wave
uni- directional only (JEDEC method) (Notes 2,3)
I FSM
40
Peak Pulse Current on 10/1000s waveform(Note 1 , Fig.3)
IPP
See Table 1
Operating and Storage Temperature Range
TJ, TSTG
-55 ~ +150
NOTES:
1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25°C per Fig.2.
2. Mounted on 5.0 mm 2(0.13mm thick) land areas.
3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum.
UNITS
Watts
Amps
Amps
°C
http://www.yeashin.com
1
REV.03 20150105