■ Tight Initial Output Voltage: < 0.05%
■ Ultralow Drift: 3ppm/°C Typical
■ Series or Shunt Operation
■ Curvature Corrected
■ Ultrahigh Line Rejection: ≈ 0.5ppm/V
■ Low Output Impedance: ≈ 0.02Ω
■ Plug-In Replacement for Present References
■ Available at 2.5V, 4.5V, 5V, and 10V
■ 100% Noise Tested
■ Temperature Output
■ Industrial Temperature Range in SO-8
■ Available in 8-Lead N8 and S8 Packages
■ Negative Shunt References
■ A/D and D/A Converters
■ Precision Regulators
■ Constant Current Sources
■ V/F Converters
■ Bridge Excitation
The LT®1019 is a third generation bandgap voltage refer-
ence utilizing thin film technology and a greatly improved
curvature correction technique. Wafer level trimming of
both reference and output voltage combines to produce
very low TC and tight initial output voltage tolerance.
The LT1019 can both sink and source up to 10mA and can
be used in either the series or shunt mode, allowing the
reference to operate with positive or negative output
voltages without external components. Minimum input/
output voltage is less than 1V in the series mode, providing
improved tolerance of low line conditions and excellent
The LT1019 is available in four voltages: 2.5V, 4.5V, 5V
and 10V. It is a direct replacement for most bandgap
references presently available including AD580, AD581,
REF-01, REF-02, MC1400, MC1404 and LM168.
, LTC and LT are registered trademarks of Linear Technology Corporation.
All other trademarks are the property of their respective owners.
Ultralinear Strain Gauge
GAIN = 100
LT1019 • TA01
*REDUCES REFERENCE AND AMPLIFIER
LOADING TO ≈0.
**IF R6 = R3, BRIDGE IS NOT LOADED BY R2 AND R4.
†A1 VOS AND DRIFT ARE NOT CRITICAL BECAUSE A2
ACTS AS A DIFFERENTIAL AMPLIFIER.
Output Voltage Drift
FULL TEMP RANGE “BOX”
0°C TO 70°C “BOX”
–50 –25 0 25 50 75