Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

ADV7120KPZ30 查看數據表(PDF) - Analog Devices

零件编号产品描述 (功能)生产厂家
ADV7120KPZ30 CMOS 80 MHz, Triple 8-Bit Video DAC ADI
Analog Devices ADI
ADV7120KPZ30 Datasheet PDF : 12 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
ADV7120
The unused analog outputs should be terminated with the same
load as that for the used channel. In other words, if the red
channel is used and IOR is terminated with a doubly terminated
75 load (37.5 ), IOB and IOG should be terminated with
37.5 resistors. (See Figure 6.)
VIDEO
INPUT
R0
IOR
R7
IOG
G0
G7
B0
IOB
B7
ADV7120
GND
DOUBLY
TERMINATED
75LOAD
37.5
37.5
Figure 6. Input and Output Connections for Stand-Alone
Gray Scale or Composite Video
Video Output Buffers
The ADV7120 is specified to drive transmission line loads,
which is what most monitors are rated as. The analog output
configurations to drive such loads are described in the Analog
Interface section and illustrated in Figure 5. However, in some
applications it may be required to drive long “transmission line”
cable lengths. Cable lengths greater than 10 meters can attenu-
ate and distort high frequency analog output pulses. The inclu-
sion of output buffers will compensate for some cable distortion.
Buffers with large full power bandwidths and gains between 2
and 4 will be required.
These buffers will also need to be able to supply sufficient cur-
rent over the complete output voltage swing. Analog Devices
produces a range of suitable op amps for such applications.
These include the AD84X series of monolithic op amps. In very
high frequency applications (80 MHz), the AD9617 is recom-
mended. More information on line driver buffering circuits is
given in the relevant op amp data sheets.
Use of buffer amplifiers also allows implementation of other
video standards besides RS-343A and RS-170. Altering the gain
components of the buffer circuit will result in any desired
video level.
Z2
Z1
+VS
0.1µF
IOR, IOG, IOB
DACs
2
7
AD848
6
3
4 0.1µF
ZS = 75
(SOURCE
TERMINATION)
–VS
ZO = 75
75
(CABLE)
GAIN (G) = 1 + Z1
Z2
ZL = 75
(MONITOR)
Figure 7. AD848 As an Output Buffer
REV. B
–9–
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]