Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

W39V040B View Datasheet(PDF) - Winbond

Part NameDescriptionManufacturer
W39V040B 512K × 8 CMOS FLASH MEMORY WITH LPC INTERFACE Winbond
Winbond Winbond
W39V040B Datasheet PDF : 32 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
W39V040B
9.5 Software Product Identification and Boot Block Lockout Detection Acquisition
Flow
Product
Identification
Entry (1)
Load data AA
to
address 5555
Product
Identification
and Boot Block
Lockout Detection
Mode (3)
Product
Identification Exit(6)
Load data AA
to
address 5555
Load data 55
to
address 2AAA
(2)
Read address = 00000
data = DA
Load data 55
to
address 2AAA
Load data 90
to
address 5555
(2)
Read address = 00001
data = 54
Load data F0
to
address 5555
Pause 10 µS
Read address = 7FFF2 (4)
Check DQ[3:0] of data
outputs
Pause 10 µS
(5)
Normal Mode
Notes for software product identification/boot block lockout detection:
(1) Data Format: DQ7DQ0 (Hex); Address Format: A14A0 (Hex)
(2) A1A18 = VIL; manufacture code is read for A0 = VIL; device code is read for A0 = VIH.
(3) The device does not remain in identification and boot block lockout detection mode if power down.
(4) The DQ[3:2] to indicate the sectors protect status as below:
DQ2
DQ3
0 64Kbytes Boot Block Unlocked by
#TBL hardware trapping
Whole Chip Unlocked by #WP hardware
trapping Except Boot Block
1 64Kbytes Boot Block Locked by #TBL Whole Chip Locked by #WP hardware
hardware trapping
trapping Except Boot Block
(5) The device returns to standard operation mode.
(6) Optional 1-write cycle (write F0 (hex.) at XXXX address) can be used to exit the product identification/boot block lockout
detection.
- 15 -
Publication Release Date: April 14, 2005
Revision A3
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]