W25Q16VZPIG View Datasheet(PDF) - Winbond

Part Name

Description

Manufacturer

W25Q16VZPIG

16M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI

Winbond 

W25Q16V

9.2 WRITE PROTECTION

Applications that use non-volatile memory must take into consideration the possibility of noise and other

adverse system conditions that may compromise data integrity. To address this concern the W25Q16

provides several means to protect data from inadvertent writes.

9.2.1 Write Protect Features

 Device resets when VCC is below threshold

 Time delay write disable after Power-up

 Write enable/disable instructions and automatic write disable after program and erase

 Software and Hardware (/WP pin) write protection using Status Register

 Write Protection using Power-down instruction

 Lock Down write protection until next power-up(1)

 One Time Program (OTP) write protection(1)

Note 1: These features are available upon special order. Please contact Winbond for details.

Upon power-up or at power-down, the W25Q16 will maintain a reset condition while VCC is below the

threshold value of VWI, (See Power-up Timing and Voltage Levels and Figure 30). While reset, all

operations are disabled and no instructions are recognized. During power-up and after the VCC voltage

exceeds VWI, all program and erase related instructions are further disabled for a time delay of tPUW.

This includes the Write Enable, Page Program, Sector Erase, Block Erase, Chip Erase and the Write

Status Register instructions. Note that the chip select pin (/CS) must track the VCC supply level at

power-up until the VCC-min level and tVSL time delay is reached. If needed a pull-up resister on /CS can

be used to accomplish this.

After power-up the device is automatically placed in a write-disabled state with the Status Register Write

Enable Latch (WEL) set to a 0. A Write Enable instruction must be issued before a Page Program,

Sector Erase, Chip Erase or Write Status Register instruction will be accepted. After completing a

program, erase or write instruction the Write Enable Latch (WEL) is automatically cleared to a write-

disabled state of 0.

Software controlled write protection is facilitated using the Write Status Register instruction and setting

the Status Register Protect (SRP0, SRP1) and Block Protect (SEC,TB, BP2, BP1 and BP0) bits. These

settings allow a portion or all of the memory to be configured as read only. Used in conjunction with the

Write Protect (/WP) pin, changes to the Status Register can be enabled or disabled under hardware

control. See Status Register for further information. Additionally, the Power-down instruction offers an

extra level of write protection as all instructions are ignored except for the Release Power-down

instruction.

- 11 -

Publication Release Date: October 7, 2009

Revision E

Share Link: