25Q16DWIP(2011) View Datasheet(PDF) - Winbond

Part Name

Description

Manufacturer

25Q16DWIP
(Rev.:2011)

1.8V 16M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI

Winbond 

W25Q16DW

10.2.14 Fast Read Quad Output (6Bh)

The Fast Read Quad Output (6Bh) instruction is similar to the Fast Read Dual Output (3Bh) instruction

except that data is output on four pins, IO0, IO1, IO2, and IO3. A Quad enable of Status Register-2 must be

executed before the device will accept the Fast Read Quad Output Instruction (Status Register bit QE

must equal 1). The Fast Read Quad Output Instruction allows data to be transferred from the W25Q16DW

at four times the rate of standard SPI devices.

The Fast Read Quad Output instruction can operate at the highest possible frequency of FR (see AC

Electrical Characteristics). This is accomplished by adding eight “dummy” clocks after the 24-bit address

as shown in Figure 13. The dummy clocks allow the device's internal circuits additional time for setting up

the initial address. The input data during the dummy clocks is “don’t care”. However, the IO pins should be

high-impedance prior to the falling edge of the first data out clock.

/CS

CLK

IO0

IO1

IO2

IO3

/CS

CLK

IO0

IO1

IO2

IO3

Mode 3

Mode 0

0 1 2 3 4 5 6 7 8 9 10

28 29 30 31

Instruction (6Bh)

24-Bit Address

23 22 21

* High Impedance

3210

High Impedance

High Impedance

* = MSB

31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Dummy Clocks

0

High Impedance

High Impedance

High Impedance

IO0 switches from

Input to Output

404040404

515151515

626262626

737373737

Byte 1 Byte 2 Byte 3 Byte 4

Figure 13. Fast Read Quad Output Instruction (SPI Mode only)

- 31 -

Publication Release Date: April 01, 2011

Preliminary - Revision A

Share Link: