25X10ALAIZ View Datasheet(PDF) - Winbond

Part Name

Description

Manufacturer

25X10ALAIZ

1M-BIT, 2M-BIT, 4M-BIT AND 8M-BIT 2.5V SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL OUTPUT SPI

Winbond 

W25X10AL, W25X20AL, W25X40AL, W25X80AL

10.2.7 Read Data (03h)

The Read Data instruction allows one more data bytes to be sequentially read from the memory. The

instruction is initiated by driving the /CS pin low and then shifting the instruction code “03h” followed

by a 24-bit address (A23-A0) into the DIO pin. The code and address bits are latched on the rising

edge of the CLK pin. After the address is received, the data byte of the addressed memory location

will be shifted out on the DO pin at the falling edge of CLK with most significant bit (MSB) first. The

address is automatically incremented to the next higher address after each byte of data is shifted out

allowing for a continuous stream of data. This means that the entire memory can be accessed with a

single instruction as long as the clock continues. The instruction is completed by driving /CS high. The

Read Data instruction sequence is shown in figure 8. If a Read Data instruction is issued while an

Erase, Program or Write cycle is in process (BUSY=1) the instruction is ignored and will not have any

effects on the current cycle. The Read Data instruction allows clock rates from D.C. to a maximum of

fR (see AC Electrical Characteristics).

Figure 8. Read Data Instruction Sequence Diagram

- 19 -

Publication Release Date: May 9, 2008

Revision B

Share Link: