Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

TPS60110 View Datasheet(PDF) - Texas Instruments

Part NameDescriptionManufacturer
TPS60110 REGULATED 5-V 300-mA LOW-NOISE CHARGE PUMP DC/DC CONVERTER TI
Texas Instruments TI
TPS60110 Datasheet PDF : 26 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
TPS60110
REGULATED 5ĆV 300ĆmA LOWĆNOISE
CHARGE PUMP DC/DC CONVERTER
SLVS215C − JUNE 1999 − REVISED AUGUST 2008
APPLICATION INFORMATION
layout
All capacitors should be soldered in close proximity to the IC. A PCB layout proposal for a two-layer board is
given in Figure 27. Care has been taken to connect both single-ended charge pumps symmetrically to the load
to achive optimized output voltage ripple performance. The proposed layout also provides improved thermal
performance as the exposed leadframe is soldered to the PCB. The bottom layer of the PCB is a ground plain
only. All ground areas on the PCB should be connected. Connect ground areas on top layer to the bottom layer
via through hole connections.
OUT
GND
GND
SYNC
ENABLE
C1+
C1−
GND
CLK
COM
SKIP
C2+
C2−
GND
GND
IN
Figure 27. Recommended PCB Layout for TPS60110 (top view)
An evaluation module for the TPS60110 is available and can be ordered under literature code SLVP132 or under
product code TPS60110EVM−132.
16
POST OFFICE BOX 655303 DALLAS, TEXAS 75265
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]