TC1271ALCVCTTR View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

TC1271ALCVCTTR

Voltage Supervisor with Manual Reset Input

Microchip Technology 

TC1270A/70AN/71A

4.2.3 POWER-DOWN/BROWN-OUTS

As the device powers-down/brown-outs, the VDD falls

from a voltage above the devices trip point (VTRIP). The

device will trip at a voltage between the maximum trip

point (VTRIP(MAX)) and the minimum trip point

(VTRIP(MIN)). Once the device voltage (VDD) goes

below this voltage, the RST/RST pin will be forced to

the active state.

Figure 4-8 shows the waveform of the RST pin as

determined by the VDD voltage. As the VDD voltage falls

from the normal operating point, the device “enters”

reset by crossing the VTRIP voltage (between

VTRIP(MAX) and VTRIP(MIN)). Then when VDD voltage

rises, the device “exits” reset by crossing the VTRIP volt-

age (below or at VTRIP(MAX)). After the “exit” state has

been detected, the Reset Delay Timer (tRST) starts.

Once the tRST time completes, the Reset pin is driven

inactive.

Table 4-3 shows the state of the RST or RST pins.

TABLE 4-3: RESET PIN STATES

Device

State of RST Pin when:

VDD < VTRIP VDD > VTRIP (1)

State of RST Pin when:

VDD < VTRIP VDD > VTRIP (1)

Output Driver

TC1270A

L

H

—

—

Push-Pull

TC1271A

—

—

H

L

Push-Pull

Note 1: The RST/RST pin will be driven inactive after the Reset Delay Timer (tRST) times out.

VDD

VTRIP

(with VDD Falling)

VTRIP

(with VDD Rising)

RST(1)

1V

< 1V is outside the

tRD

device specifications

tRST

tRD

tRST

FIGURE 4-8:

Note 1: The TC1270AN requires an external pull-up resistor.

RST Operation as determined by the VTRIP.

DS22035B-page 20

© 2007 Microchip Technology Inc.

Share Link: