P89LPC9321FN View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

Manufacturer

P89LPC9321FN

8-bit microcontroller with accelerated two-clock 80C51 core 8 kB 3 V byte-erasable flash with 512-byte data EEPROM

NXP Semiconductors. 

NXP Semiconductors

P89LPC9321

8-bit microcontroller with accelerated two-clock 80C51 core

7.20.6 Timer overflow toggle output

Timers 0 and 1 can be configured to automatically toggle a port output whenever a timer

overflow occurs. The same device pins that are used for the T0 and T1 count inputs are

also used for the timer toggle outputs. The port outputs will be a logic 1 prior to the first

timer overflow when this mode is turned on.

7.21 RTC/system timer

The P89LPC9321 has a simple RTC that allows a user to continue running an accurate

timer while the rest of the device is powered down. The RTC can be a wake-up or an

interrupt source. The RTC is a 23-bit down counter comprised of a 7-bit prescaler and a

16-bit loadable down counter. When it reaches all logic 0s, the counter will be reloaded

again and the RTCF flag will be set. The clock source for this counter can be either the

CPU clock (CCLK) or the XTAL oscillator. Only power-on reset and watchdog reset will

reset the RTC and its associated SFRs to the default state.

The 16-bit loadable counter portion of the RTC is readable by reading the RTCDATL and

RTCDATH registers.

7.22 CCU

This unit features:

• A 16-bit timer with 16-bit reload on overflow.

• Selectable clock, with prescaler to divide clock source by any integral number

between 1 and 1024.

• Four compare/PWM outputs with selectable polarity

• Symmetrical/asymmetrical PWM selection

• Two capture inputs with event counter and digital noise rejection filter

• Seven interrupts with common interrupt vector (one overflow, two capture, four

compare)

• Safe 16-bit read/write via shadow registers.

7.22.1 CCU clock

The CCU runs on the CCUCLK, which is either PCLK in basic timer mode, or the output of

a PLL. The PLL is designed to use a clock source between 0.5 MHz to 1 MHz that is

multiplied by 32 to produce a CCUCLK between 16 MHz and 32 MHz in PWM mode

(asymmetrical or symmetrical). The PLL contains a 4-bit divider to help divide PCLK into a

frequency between 0.5 MHz and 1 MHz.

7.22.2 CCUCLK prescaling

This CCUCLK can further be divided down by a prescaler. The prescaler is implemented

as a 10-bit free-running counter with programmable reload at overflow.

7.22.3 Basic timer operation

The timer is a free-running up/down counter with a direction control bit. If the timer

counting direction is changed while the counter is running, the count sequence will be

reversed. The timer can be written or read at any time.

P89LPC9321_1

Product data sheet

Rev. 01 — 9 December 2008

© NXP B.V. 2008. All rights reserved.

32 of 70

Share Link: