DatasheetQ Logo
Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

NBB-400 View Datasheet(PDF) - RF Micro Devices

Part Name
Description
Manufacturer
NBB-400 Datasheet PDF : 10 Pages
1 2 3 4 5 6 7 8 9 10
NBB-400
Pin Function Description
Interface Schematic
1
RF IN
RF input pin. This pin is NOT internally DC blocked. A DC blocking
capacitor, suitable for the frequency of operation, should be used in
most applications. DC coupling of the input is not allowed, because this
will override the internal feedback loop and cause temperature instabil-
ity.
2
GND
Ground connection. For best performance, keep traces physically short
and connect immediately to ground plane.
3
RF OUT RF output and bias pin. Biasing is accomplished with an external series
resistor and choke inductor to VCC. The resistor is selected to set the
DC current into this pin to a desired level. The resistor value is deter-
mined by the following equation:
R = (---V----C---C-----–----V----D----E---V---I--C----E----)
ICC
RF IN
Care should also be taken in the resistor selection to ensure that the
current into the part never exceeds maximum datasheet operating cur-
rent over the planned operating temperature. This means that a resistor
between the supply and this pin is always required, even if a supply
near 5.0V is available, to provide DC feedback to prevent thermal run-
away. Because DC is present on this pin, a DC blocking capacitor, suit-
able for the frequency of operation, should be used in most
applications. The supply side of the bias network should also be well
bypassed.
RF OUT
4
GND
Same as pin 2.
Rev A5 031106
4-35
 

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]