MCP6141 View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
MCP6141 Datasheet PDF : 38 Pages
| |||
4.9 Application Circuits
4.9.1 BATTERY CURRENT SENSING
The MCP6141/2/3/4 op amps’ Common Mode Input
Range, which goes 0.3V beyond both supply rails,
supports their use in high side and low side battery
current sensing applications. The very low quiescent
current (0.6 µA, typical) help prolong battery life, and
the rail-to-rail output supports detection low currents.
Figure 4-10 shows a high side battery current sensor
circuit. The 1 kΩ resistor is sized to minimize power
losses. The battery current (IDD) through the 1 kΩ
resistor causes its top terminal to be more negative
than the bottom terminal. This keeps the common
mode input voltage of the op amp below VDD, which is
within its allowed range. When no current is flowing, the
output will be at its Maximum Output Voltage Swing
(VOH), which is virtually at VDD.
.
1.4V
to
6.0V
IDD
1 kΩ
MCP6141
VDD
VOUT
100 kΩ
1 MΩ
VOUT = VDD – (1 kΩ)(11 V/V)IDD
FIGURE 4-10:
Sensor.
High Side Battery Current
MCP6141/2/3/4
4.9.2 INVERTING SUMMING AMPLIFIER
The MCP6141/2/3/4 op amp is well suited for the
inverting summing amplifier shown in Figure 4-11 when
the resistors at the input (R1, R2, and R3) make the
noise gain at least 10 V/V. The output voltage (VOUT) is
a weighted sum of the inputs (V1, V2, and V3), and is
shifted by the VREF input. The necessary calculations
follow in Equation 4-3.
.
R1
V1
R2
V2
R3
V3
VREF
RF
MCP614X
VOUT
FIGURE 4-11:
Summing Amplifier.
EQUATION 4-3:
Noise Gain:
GN
=
1
+
RF
⎛
⎝
--1---
R1
+
--1---
R2
+
R--1--3-⎠⎞
≥ 10
V/V
Signal Gains:
G1 = –RF ⁄ R1
G2 = –RF ⁄ R2
G3 = –RF ⁄ R3
Output Signal:
VOUT = V1G1 + V2G2 + V3G3 + VREFGN
© 2009 Microchip Technology Inc.
DS21668D-page 19
|
|
Share Link: 