MC-458CB647
DC Characteristics (Recommended Operating Conditions Unless Otherwise Noted)
Parameter
Symbol
Test condition
MIN. MAX. Unit Notes
Operating current
ICC1 Burst length = 1
/CAS latency = 2
tRC ≥ tRC(MIN.), IO = 0 mA
/CAS latency = 3
Precharge standby current in ICC2P CKE ≤ VIL(MAX.), tCK = 15 ns
power down mode
ICC2PS CKE ≤ VIL(MAX.), tCK = ∞
Precharge standby current in ICC2N CKE ≥ VIH(MIN.), tCK = 15 ns, /CS ≥ VIH(MIN.),
non power down mode
Input signals are changed one time during 30 ns.
440
mA
1
460
4
mA
4
80
mA
Active standby current in
power down mode
Active standby current in
non power down mode
ICC2NS CKE ≥ VIH(MIN.), tCK = ∞, Input signals are stable.
ICC3P CKE ≤ VIL(MAX.), tCK = 15 ns
ICC3PS CKE ≤ VIL(MAX.), tCK = ∞
ICC3N CKE ≥ VIH(MIN.), tCK = 15 ns, /CS ≥ VIH(MIN.),
Input signals are changed one time during 30 ns.
32
20
mA
16
120
mA
Operating current
ICC3NS CKE ≥ VIH(MIN.), tCK = ∞, Input signals are stable.
ICC4 tCK ≥ tCK(MIN.), IO = 0 mA
/CAS latency = 2
80
580
mA
2
(Burst mode)
/CAS latency = 3
740
CBR (Auto) refresh current
ICC5
tRC ≥ tRC(MIN.)
/CAS latency = 2
920
mA
3
/CAS latency = 3
960
Self refresh current
Input leakage current
Output leakage current
High level output voltage
ICC6 CKE ≤ 0.2 V
II(L) VI = 0 to 3.6 V, All other pins not under test = 0 V
IO(L) DOUT is disabled, VO = 0 to 3.6 V
VOH IO = –4.0 mA
8
mA
–4
+4
µA
–1.5 +1.5
µA
2.4
V
Low level output voltage
VOL IO = +4.0 mA
0.4
V
Notes 1. ICC1 depends on output loading and cycle rates. Specified values are obtained with the output open. In
addition to this, ICC1 is measured on condition that addresses are changed only one time during tCK (MIN.).
2. ICC4 depends on output loading and cycle rates. Specified values are obtained with the output open. In
addition to this, ICC4 is measured on condition that addresses are changed only one time during tCK (MIN.).
3. ICC5 is measured on condition that addresses are changed only one time during tCK (MIN.).
6
Data Sheet M14279EJ4V0DS00