Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

MB3790PF 데이터 시트보기 (PDF) - Fujitsu

부품명상세내역제조사
MB3790PF Battery Backup IC Fujitsu
Fujitsu Fujitsu
MB3790PF Datasheet PDF : 21 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
MB3790
(4) Momentary power failure or voltage dip
When the power supply voltage drops less than or equal to VINL. (4.2 V typ) as the power supply goes down or its
voltage dips momentarily, the RESET pin outputs a High level and the RESET pin outputs a low level. The devices
such as SRAM or a microprocessor are thereby placed in the standby mode and powered from the battery. When
in this mode, the primary battery voltage detection and the secondary battery recharging operations are stopped.
Note: To guarantee backup operation in case of momentary power failure, make sure the 5 V-to-0 V fall time on VIN
is 50 µs or more by using, for example, a capacitator.
2. Alarm Operation
V BAT1
DV BAT2 DV BAT1
V BATH1
V BATL1
V BATH2
V BATL2
ALARM1
(1)
(1)
ALARM2
(2)
(2)
If the primary battery voltage decreases while the power supply voltage (VIN) is greater than or equal to VINH (4.3 V
typ), alarm signals are output as described below. At this time, if the VBAT1 pin is released open, the output from the
alarm pin becomes indeterminate.
(1) Primary battery replacement alarm (alarm-1 output)
If the primary battery voltage drops to VBAT1 (2.65 V typ), the ALARM1 pin is forced to a Low level to issue an alarm
indicating that it’s time to replace the primary battery.
(2) Primary battery minimum voltage alarm (alarm-2 output)
If the primary battery voltage further drops to VBAT2 (2.37 V typ), the ALARM2 pin is forced to a Low level to issue
an alarm indicating that the primary battery power has dropped below the voltage necessary to retain the SRAM
data (approx. 2.0 V).
7
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]