Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

MB3790PF 데이터 시트보기 (PDF) - Fujitsu

부품명상세내역제조사
MB3790PF Battery Backup IC Fujitsu
Fujitsu Fujitsu
MB3790PF Datasheet PDF : 21 Pages
First Prev 11 12 13 14 15 16 17 18 19 20
MB3790
s APPLICATION
1. Method of Using the CONTROL Pin
It is possible to control the operation of analog switch 1 by entering a High or Low level to the CONTROL pin while
being powered by the battery. The Table below shows how the analog switch operates when its operation is controlled
from the CONTROL pin.
When using the primary and the secondary batteries in combination as in the case of memory cards, be sure to
set the CONTROL pin High to prevent the primary battery from being recharged by the secondary battery current
flowing from analog switch 1.
• Control Conditions of CONTROL Pin
Operating state
Standby/active state
Backup state
Control conditions
Input voltage (VIN) CONTROL pin*1
VIN > VINL
High/Low
VINL > VIN
High (= VOUT)
VINL > VIN
Low (= GND)
ON/OFF State of analog switch*2
Analog switch 1 Analog switch 2
OFF
OFF
OFF
ON
ON
ON
*1: If the CONTROL pin is released open, the logic state of the CMOS circuit may become instable letting current
flow into the circuit. Therefore, the CONTROL pin must always have a High or Low level input.
*2: The ON-resistance of the analog switch is approximately 10 K ohms.
Analog Switch connection Diagram
V OUT
Analog Switch 1
SBD
Analog Switch 2
V BAT1
Connection to the
primary battery
V BAT2
Connection to the
secondary battery
15
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]