DatasheetQ Logo
Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

M45PE40-VMN6P View Datasheet(PDF) - Numonyx -> Micron

Part Name
Description
Manufacturer
M45PE40-VMN6P Datasheet PDF : 46 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
SPI modes
3
SPI modes
M45PE40
These devices can be driven by a microcontroller with its SPI peripheral running in either of
the two following modes:
CPOL=0, CPHA=0
CPOL=1, CPHA=1
For these two modes, input data is latched in on the rising edge of Serial Clock (C), and
output data is available from the falling edge of Serial Clock (C).
The difference between the two modes, as shown in Figure 4, is the clock polarity when the
bus master is in Stand-by mode and not transferring data:
C remains at 0 for (CPOL=0, CPHA=0)
C remains at 1 for (CPOL=1, CPHA=1)
Figure 3. Bus master and memory devices on the SPI bus
R
SPI Interface with
(CPOL, CPHA) =
(0, 0) or (1, 1)
SDO
SDI
SCK
SPI Bus Master
VSS
VCC
CQD
VCC
VSS
CQD
VCC
VSS
C Q D VCC
VSS
CS3 CS2 CS1
R
SPI Memory R
Device
SPI Memory R
Device
SPI Memory
Device
S
W HOLD
S
W HOLD
S
W HOLD
10/46
AI12836b
1. The Write Protect (W) signal should be driven, High or Low as appropriate.
Figure 3 shows an example of three devices connected to an MCU, on an SPI bus. Only one
device is selected at a time, so only one device drives the Serial Data Output (Q) line at a
time, the other devices are high impedance. Resistors R (represented in Figure 3) ensure
that the M45PE40 is not selected if the Bus Master leaves the S line in the high impedance
state. As the Bus Master may enter a state where all inputs/outputs are in high impedance
at the same time (for example, when the Bus Master is reset), the clock line (C) must be
connected to an external pull-down resistor so that, when all inputs/outputs become high
impedance, the S line is pulled High while the C line is pulled Low (thus ensuring that S and
C do not become High at the same time, and so, that the tSHCH requirement is met). The
typical value of R is 100 kΩ, assuming that the time constant R*Cp (Cp = parasitic
capacitance of the bus line) is shorter than the time during which the Bus Master leaves the
SPI bus in high impedance.
 

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]