Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

M29W320EB View Datasheet(PDF) - Numonyx -> Micron

Part NameDescriptionManufacturer
M29W320EB 32Mbit (4Mbx8 or 2Mbx16, Uniform Parameter Blocks, Boot Block) 3V supply Flash memory Numonyx
Numonyx -> Micron Numonyx
M29W320EB Datasheet PDF : 63 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
Command interface
M29W320ET, M29W320EB
4.5
4.5.1
4.5.2
Fast Program commands
There are two Fast Program commands available to improve the programming throughput,
by writing several adjacent words or bytes in parallel. The Quadruple byte Program
command is available for x8 operations, while the Double word Program command is
available for x16 operations.
Fast Program commands should not be attempted when VPP/WP is not at VPP. Care must
be taken because applying a 12V VPP voltage to the VPP/WP pin will temporarily unprotect
any protected block.
After programming has started, Bus Read operations output the Status register content.
After the program operation has completed the memory will return to the Read mode, unless
an error has occurred. When an error occurs Bus Read operations will continue to output
the Status register. A Read/Reset command must be issued to reset the error condition and
return to Read mode.
Note that the Fast Program commands cannot change a bit set at ’0’ back to ’1’. One of the
Erase Commands must be used to set all the bits in a block or in the whole memory from ’0’
to ’1’.
Typical Program times are given in Table 6: Program, Erase times and Program, Erase
Endurance cycles
Quadruple byte Program command
The Quadruple byte Program command is used to write a page of four adjacent bytes in
parallel. The four bytes must differ only for addresses A0, DQ15A-1. Five bus write cycles
are necessary to issue the Quadruple byte Program command.
1. The first bus cycle sets up the Quadruple byte Program command.
2. The second bus cycle latches the Address and the Data of the first byte to be written.
3. The third bus cycle latches the Address and the Data of the second byte to be written.
4. The fourth bus cycle latches the Address and the Data of the third byte to be written.
5. The fifth bus cycle latches the Address and the Data of the fourth byte to be written and
starts the Program/Erase Controller.
Double word Program command
The Double word Program command is used to write a page of two adjacent words in
parallel. The two words must differ only for the address A0.
Three bus write cycles are necessary to issue the Double word Program command.
1. The first bus cycle sets up the Double word Program command.
2. The second bus cycle latches the Address and the Data of the first word to be written.
3. The third bus cycle latches the Address and the Data of the second word to be written
and starts the Program/Erase Controller.
22/63
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]