EDD5104ABTA-6B View Datasheet(PDF) - Elpida Memory, Inc

Part Name

Description

Manufacturer

EDD5104ABTA-6B

512M bits DDR SDRAM

Elpida Memory, Inc 

EDD5104ABTA, EDD5108ABTA

NOTES FOR CMOS DEVICES

1 PRECAUTION AGAINST ESD FOR MOS DEVICES

Exposing the MOS devices to a strong electric field can cause destruction of the gate

oxide and ultimately degrade the MOS devices operation. Steps must be taken to stop

generation of static electricity as much as possible, and quickly dissipate it, when once

it has occurred. Environmental control must be adequate. When it is dry, humidifier

should be used. It is recommended to avoid using insulators that easily build static

electricity. MOS devices must be stored and transported in an anti-static container,

static shielding bag or conductive material. All test and measurement tools including

work bench and floor should be grounded. The operator should be grounded using

wrist strap. MOS devices must not be touched with bare hands. Similar precautions

need to be taken for PW boards with semiconductor MOS devices on it.

2 HANDLING OF UNUSED INPUT PINS FOR CMOS DEVICES

No connection for CMOS devices input pins can be a cause of malfunction. If no

connection is provided to the input pins, it is possible that an internal input level may be

generated due to noise, etc., hence causing malfunction. CMOS devices behave

differently than Bipolar or NMOS devices. Input levels of CMOS devices must be fixed

high or low by using a pull-up or pull-down circuitry. Each unused pin should be connected

to VDD or GND with a resistor, if it is considered to have a possibility of being an output

pin. The unused pins must be handled in accordance with the related specifications.

3 STATUS BEFORE INITIALIZATION OF MOS DEVICES

Power-on does not necessarily define initial status of MOS devices. Production process

of MOS does not define the initial operation status of the device. Immediately after the

power source is turned ON, the MOS devices with reset function have not yet been

initialized. Hence, power-on does not guarantee output pin levels, I/O settings or

contents of registers. MOS devices are not initialized until the reset signal is received.

Reset operation must be executed immediately after power-on for MOS devices having

reset function.

CME0107

Preliminary Data Sheet E0237E30 (Ver. 3.0)

49

Share Link: