DatasheetQ Logo
Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

TS1851AI View Datasheet(PDF) - STMicroelectronics

Part Name
Description
Manufacturer
TS1851AI Datasheet PDF : 24 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
TS185x, TS185xA
Absolute maximum ratings and operating conditions
1
Absolute maximum ratings and operating conditions
Table 2. Absolute maximum ratings
Symbol
Parameter
Value
Unit
VCC
Vid
Vi
Toper
Tstg
Tj
Rthja
Supply voltage (1)
Differential input voltage(2)
Input voltage
Operating free-air temperature range
Storage temperature
Maximum junction temperature
Thermal resistance junction to ambient (3)
SOT23-5
miniSO-8
SO-8
SO-14
TSSOP8
TSSOP14
7
±1
VCC- -0.3 to VCC+ +0.3
-40 to + 125
-65 to +150
150
250
190
125
103
120
100
V
V
V
°C
°C
°C
°C/W
Rthjc
ESD
Thermal resistance junction to case
SOT23-5
miniSO-8
SO-8
SO-14
TSSOP8
TSSOP14
HBM: human body model(4)
MM: machine model(5)
CDM: charged device model(6)
81
39
40
°C/W
31
37
32
2
kV
200
V
1.5
kV
Lead temperature (soldering, 10sec)
Output short-circuit duration
250
°C
See note(7)
1. All voltage values, except differential voltages, are with respect to network terminal.
2. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. If
Vid > ±1 V, the maximum input current must not exceed ±1 mA. When Vid > ±1 V, add an input series
resistor to limit the input current.
3. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-
circuits on all amplifiers.
4. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5 kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
5. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
6. Charged device model: all pins and package are charged together to the specified voltage and then
discharged directly to ground through only one pin. This is done for all pins.
7. Short-circuits from the output to VCC can cause excessive heating. The maximum output current is
approximately 48 mA, independent of the magnitude of VCC. Destructive dissipation can result from
simultaneous short-circuits on all amplifiers.
Doc ID 6991 Rev 4
3/24
 

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]