Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

ISD5102 View Datasheet(PDF) - Winbond

Part NameDescriptionManufacturer
ISD5102 SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY Winbond
Winbond Winbond
ISD5102 Datasheet PDF : 88 Pages
First Prev 31 32 33 34 35 36 37 38 39 40 Next Last
ISD5100 – SERIES
1. Gain from ANA IN to SP+/-
2. Gain from ANA IN to ARRAY IN
3. 0TLP Input is the reference Transmission Level Point that is used for testing. This level is
typically 3 dB below clipping
4. Speaker Out gain set to 1.6 (High). (Differential)
AUX IN (Auxiliary Input)
The AUX IN is an additional audio input to the ISD5100-Series, such as from the microphone circuit in
a mobile phone “car kit.” This input has a nominal 694 mV p-p level at its minimum gain setting (0 dB).
See the following table. Additional gain is available in 3 dB steps (controlled by the I2C interface) up to
9 dB.
AUX IN Input Modes
CCOUP = 0.1 µF
AUX IN
Input
Internal to the device
Rb
Ra
ANA IN
Input Amplifier
NOTE: fCUTTOFF
1
2xRaCCOUP
Gain
Setting
00
01
10
11
Resistor Ratio
(Rb/Ra)
40.1 / 40.1
47.0 / 33.2
53.5 / 26.7
59.2 / 21
Note: Ra & Rb are in k
Gain
1.0
1.414
2.0
2.82
Gain(2)
(dB)
0
3
6
9
Setting(1)
0 dB
3 dB
6 dB
9 dB
0TLP Input
VP-P(3)
0.694
0.491
0.347
0.245
AUX IN Amplifier Gain Settings
CFG0
Gain(2)
AXG1
AXG0
0
0
1.00
0
1
1.41
1
0
2.00
1
1
2.82
Array
In/Out VP-P
0.694
0.694
0.694
0.694
Speaker
Out VP-P(4)
0.694
0.694
0.694
0.694
1. Gain from AUX IN to ANA OUT
2. Gain from AUX IN to ARRAY IN
3. 0TLP Input is the reference Transmission Level Point that is used for testing. This level is typically
3 dB below clipping
4. Differential
- 35 -
Publication Release Date: October, 2003
Revision 0.2
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]