I5216-P View Datasheet(PDF) - Winbond
Part Name
Description
Manufacturer
I5216-P Datasheet PDF : 83 Pages
| |||
I5216 SERIES
Advanced Information
PRELIMINARY
PIN DESCRIPTION
Pin Name Pin No. Pin No.
RAC
28-pin
TSOP
4
28-pin
PDIP
25
/INT
5
26
MCLK
6
27
SCL
9
2
SDA
11
4
A0
12
5
A1
10
3
MIC+
16
9
MIC-
17
10
MICBS
18
11
ACAP
19
12
SP+
22
15
SP-
20
13
AUX IN
24
17
AUX OUT
25
18
SDI
SDIO
WS
SCK
VCCD
2
23
3
24
28
21
27
20
7,8
1,28
VSSD
VSSA
VCCA
13,14
1,15,21
23
6,7
8,14,22
16
NC
26
19
Pin No. Functionality
28-pin
SOIC
25
26
27
2
4
7
3
10
9
8
12
15
13
17
20
22
24
18
19
1,28
5,6
11,14,23
16
21
Row Address Clock; an open drain output. The RAC pin goes LOW
TRACLO1 before the end of each row of memory, and returns HIGH
at exactly the end of each row of memory.
Interrupt Output; an open drain output indicating that a set EOM bit
has been found during Playback, or that the chip is in an Overflow
(OVF) condition. This pin remains LOW until a Read Status
command is executed.
This pin allows the internal clock of the Voice record/playback
system to be externally driven for enhanced timing precision. This
pin is grounded for most applications. It is required for the CODEC
operation.
Serial Clock Line is part of the I2C serial bus. It is used to clock the
data into and out of the I2C interface.
Serial Data Line is part of the I2C serial bus. Data is passed
between devices on the bus over this line.
Input pin that supplies the LSB for the I2C Slave Address.
Input pin that supplies the LSB +1 bit for the I2C Slave Address.
Differential positive Input to the microphone amplifier.
Differential negative Input to the microphone amplifier.
Microphone Bias Voltage
AGC Capacitor connection. Required for the on-chip AGC amplifier.
Differential Positive Speaker Driver Output.
Differential Negative Speaker Driver Output. When the speaker
outputs are in use, the AUX OUT output is disabled.
Auxiliary Input. This is one of the gain adjustable analog inputs for
the device.
Auxiliary Output. This is one the analog outputs for the device.
When this output is in use, the SP+ and SP- outputs are disabled.
Serial Digital Audio PCM Input.
Serial Digital Audio PCM Output or I2S Input/Output.
Digital audio PCM Frame sync (FS) or I2S Word Sync (WS).
Digital audio PCM or I2S Serial Clock.
Positive Digital Supply pins. These pins carry noise generated by
internal clocks in the chip. They must be carefully bypassed to
Digital Ground to ensure correct device operation.
Digital Ground pins.
Analog Ground pins.
Positive Analog Supply pin. This pin supplies the low level audio
sections for the device. It should be carefully bypassed to Analog
Ground to ensure correct device operation.
No Connection
1 See parameters section of the datasheet.
-5
Publication Release Date: November 30, 2001
Revision A1
|
|
Share Link: 