DatasheetQ Logo
Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

GS1531-CB View Datasheet(PDF) - Gennum -> Semtech

Part Name
Description
Manufacturer
GS1531-CB Datasheet PDF : 50 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
GS1531 Data Sheet
Table 1-1: Pin Descriptions (Continued)
Pin
Number
Name
Timing
F10, F9,
G10, G9,
H10, H9,
J10, J9,
K10, K9
DIN[9:0]
Synchronous
with PCLK
G4
IOPROC_EN/DIS
Non
Synchronous
Type
Input
Input
Description
PARALLEL DATA BUS
Signal levels are LVCMOS/LVTTL compatible.
DIN9 is the MSB and DIN0 is the LSB.
HD 20-bit mode
SD/HD = LOW
20bit/10bit = HIGH
Chroma data input in SMPTE mode
SMPTE_BYPASS =HIGH
DVB_ASI = LOW
Data input in Data-Through mode
SMPTE_BYPASS = LOW
DVB_ASI = LOW
HD 10-bit mode
SD/HD = LOW
20bit/10bit = LOW
High impedance in all modes.
SD 20-bit mode
SD/HD = HIGH
20bit/10bit = HIGH
Chroma data input in SMPTE mode
SMPTE_BYPASS = HIGH
DVB_ASI = LOW
Data input in Data-Through mode
SMPTE_BYPASS = LOW
DVB_ASI = LOW
High impedance in DVB-ASI mode
SMPTE_BYPASS = LOW
DVB_ASI = HIGH
SD 10-bit mode
SD/HD = HIGH
20bit/10bit = LOW
High impedance in all modes.
CONTROL SIGNAL INPUT
Signal levels are LVCMOS/LVTTL compatible.
Used to enable or disable I/O processing features.
When set HIGH, the following I/O processing features of the device are
enabled:
• EDH Packet Generation and Insertion (SD-only)
• SMPTE 352M Packet Generation and Insertion
• ANC Data Checksum Calculation and Insertion
• Line-based CRC Generation and Insertion (HD-only)
• Line Number Generation and Insertion (HD-only)
• TRS Generation and Insertion
• Illegal Code Remapping
To enable a subset of these features, keep IOPROC_EN/DIS HIGH and
disable the individual feature(s) in the IOPROC_DISABLE register
accessible via the host interface.
When set LOW, the I/O processing features of the device are disabled,
regardless of whether the features are enabled in the IOPROC_DISABLE
register.
30573 - 7 February 2008
9 of 50
 

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]