Table 4-29: Audio Control Packet Word Descriptions
Name
ADF
No of Words
3
Description
Ancillary Data Flag
DID
1
Audio Group Data ID
DBN
1
DC
1
AF
1
Data Block Number
Data Count
Audio Frame Number
Data
000h
3FFh
3FFh
1E3h
2E2h
2E1h
1E0h
200h
10Bh
–
RATE
1
Sampling Frequency
–
ACT
1
DEL1-2
3
Active Channel
–
Ch1/2 Delay Data
–
DEL3-4
3
Ch3/4 Delay Data
–
RSRV
2
Reserved Words
200h
CS
1
Checksum. Calculates
–
the sum of lower 9 bits
of 15 words from DID
4.10.2 Audio Control Packet DID Setting
To multiplex audio control packets for audio channels 1 to 4 (inputs AIN1/2 and AIN3/4),
the CTRONA bit 2 of Host Interface register 02Fh must be set HIGH. To multiplex audio
control packets for audio channels 5 to 8 (inputs AIN5/6 and AIN7/8), the CTRONB bit 2
of Host Interface register 020h must be set HIGH.
The audio control packet group DID for audio input channels 1 to 4 is set in CTRIDA[1:0]
bits 1-0 of Host Interface register 02Fh. The audio control packet group DID for audio
input channels 5 to 8 is set in CTRIDB[1:0] bits 3-2 of Host Interface register 020h.
Table 4-30 shows the 2-bit Host Interface setting for the corresponding audio control
packet group DID.
When CASCADE is set LOW (external pin or register), the GS1503B will default to audio
groups 1 and 2, where the audio control packet for AIN1/2 and AIN3/4 will be
multiplexed with group 1 DID, and AIN5/6 and AIN7/8 with group 2 DID.
Control packet data can be programmed via the corresponding registers in the Host
Interface.
GS1503B HD Embedded Audio CODEC
Data Sheet
37953 - 1
December 2009
Auto-Generation
Yes
See Table 4-30 in
Section 5.8.2
Yes
Yes
9-bit Host Interface
Setting
4-bit Host Interface
Setting
CHACT[7:0] setting
26-bit Host Interface
setting
26-bit Host Interface
setting
18-bit Host Interface
setting
Yes
39 of 90