The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
DF22 Series●7.92 mm Contact Pitch, High-Current Connectors for Internal Power Supplies (UL, C-UL and TÜV Listed)
■Tools
Type
Item
Part Number
Press unit
CM-105
Automatic
Applicators are used in automatic crimping
machines manufactured by Hirose Electric
Applicators are used in automatic
crimping machines manufactured by
other companies
AP105-DF22-1416
AP105-DF22A-1416
AP109A-DF22-1416
AP109A-DF22A-1416
AP109A-DF22A-1012
HT104/DF22-1416
Manual Crimp tools
HT104/DF22A-1416
HT103/DF22A-1012
Note 1: When crimping contact DF22A-1012SCF use a press with 3.5 ton min.
Note 2: AP109A type applicators cannot be used with the CM-105 press.
CL No.
901-0005-4
901-4576-7
901-4578-2
901-4579-5
901-4580-4
901-4582-0
550-0285-0
550-0286-2
550-0288-8
Applicable Contacts
DF22/DF22A-1416SCF/PCF
DF22-1416SCF/PCF
DF22A-1416SCF/PCF
DF22-1416SCF/PCF
DF22A-1416SCF/PCF
DF22A-1012SCF
DF22-1416SC/PC
DF22A-1416SC/PC
DF22A-1012SC
■Contact Extraction
■ Contact extraction tool: Flat-bladed screwdriver, 1.4 mm blade width
■ Intended crimp Contacts: DF22-1416SC(F), DF22A-1416SC(F), DF22A-1012SC(F), DF22-1416PC(F), and DF22A-1416PC(F)
■ Work Method
Housing Cross-Sectional Diagram
(1)
Flat-bladed screwdriver
1. Refer to the drawing No. 1. Insert
correct size screwdriver in the
insulator against the molded-in
lance. Deflect the lance as shown.
Molded-in lance
(2)
2. Assure that the lance is deflected
to release the contact and pull- out
wire with the terminated contact.
■Precautions
●Make sure that the lock is fully depressed before un-mating the connectors.
●Use correct size of the wires. Do NOT forcefully twist or deform wires, as this may affect the
crimped contact connection.
15