D102ED View Datasheet(PDF) - MicroPower Direct, LLC
Part Name
Description
Manufacturer
D102ED Datasheet PDF : 2 Pages
| |||
D100ED Series
Very Low Cost, 1W SIP
Dual Isolated Output
DC/DC Converters
Key Features:
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
• 1W Output Power
5 VDC Input 4.5 5.0 5.5
• Miniature SIP Case
• UL Approved (File E245422)
• Dual Isolated Outputs
• 1,000 VDC Isolation
• >3.5 MHour MTBF
• 12 Standard Models
• Industry Standard Pin-Out
Input Voltage Range
Input Filter
Reverse Polarity Input Current
Output
Parameter
Output Voltage Accuracy
Line Regulation
12 VDC Input 10.8 12.0 13.2
24 VDC Input 21.6 24.0 26.4
Internal Capacitor
0.3
VDC
A
Conditions
Min.
For Vin Change of 1%
Typ.
±3.0
±1.2
Max.
±3.0
Units
%
%
• LOWEST COST!!
Load Regulation
Iout = 10% to 100%
±15.0
Ripple (20 MHz)
See Note 2
50 75 mV P - P
Noise (20 MHz)
See Note 2
75 150 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.03 %/ºC
Output Short Circuit
Momentary (0.5 Sec.)
General
RoHS Compliant Parameter
Isolation Voltage, Input/Output
Conditions
Min. Typ. Max.
60 Seconds 1,000
Units
VDC
Isolation Voltage, Output/Output
1,000
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
60
pF
Switching Frequency
100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Humidity
Physical
Case Size
Case Material
Weight
RH, Non-condensing
95
%
0.77 x 0.24 x 0.39 Inches (19.6 x 6.0 x 10.0 mm)
Non-Conductive Black Plastic (UL94-V0)
0.07 Oz (2.1g)
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 3.5
Units
MHours
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input -0.7
9.0
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
18.0
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
450
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
|
|
Share Link: 