Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits
Part Name  

Q67060-S6101-A3 View Datasheet(PDF) - Siemens AG

Part NameQ67060-S6101-A3 Siemens
Siemens AG Siemens
DescriptionSmart Highside Power Switch
Q67060-S6101-A3 Datasheet PDF : 14 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
BTS 410 D2
Pin
Symbol
Function
1
GND
- Logic ground
2
IN
I Input, activates the power switch in case of logical high signal
3
Vbb
+ Positive power supply voltage,
the tab is shorted to this pin
4
ST
S Diagnostic feedback, low on failure
5
OUT
O Output to the load
(Load, L)
Maximum Ratings at Tj = 25 °C unless otherwise specified
Parameter
Symbol
Supply voltage (overvoltage protection see page 3)
Load dump protection2) VLoadDump = UA + Vs, UA = 13.5 V
RI3)= 2 , RL= 6.6 , td= 400 ms, IN= low or high
Vbb
VLoad dump4)
Load current (Short circuit current, see page 4)
IL
Operating temperature range
Tj
Storage temperature range
Tstg
Power dissipation (DC), TC 25 °C
Ptot
Inductive load switch-off energy dissipation, single pulse
Vbb = 12V, Tj,start = 150°C, TC = 150°C const.
IL = 1.8 A, ZL = 2.3 H, 0 : EAS
Electrostatic discharge capability (ESD)
IN: VESD
(Human Body Model)
all other pins:
acc. MIL-STD883D, method 3015.7 and ESD assn. std. S5.1-1993
Input voltage (DC)
VIN
Current through input pin (DC)
IIN
Current through status pin (DC)
IST
see internal circuit diagrams page 6
Values Unit
65 V
100 V
self-limited A
-40 ...+150 °C
-55 ...+150
50 W
4.5
J
1 kV
2
-0.5 ... +6 V
±5.0 mA
±5.0
Thermal Characteristics
Parameter and Conditions
Symbol
Thermal resistance
chip - case: RthJC
junction - ambient (free air): RthJA
SMD version, device on PCB5):
Values
Unit
min typ max
--
-- 2.5 K/W
--
-- 75
-- 35
--
2) Supply voltages higher than Vbb(AZ) require an external current limit for the GND and status pins, e.g. with a
150 resistor in the GND connection and a 15 kresistor in series with the status pin. A resistor for the
protection of the input is integrated.
3) RI = internal resistance of the load dump test pulse generator
4) VLoad dump is setup without the DUT connected to the generator per ISO 7637-1 and DIN 40839
5) Device on 50mm*50mm*1.5mm epoxy PCB FR4 with 6cm2 (one layer, 70µm thick) copper area for Vbb
connection. PCB is vertical without blown air.
Semiconductor Group
2
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]