Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits
Part Name  

APA1000-PQG208ES View Datasheet(PDF) - Actel Corporation

Part NameAPA1000-PQG208ES ACTEL
Actel Corporation ACTEL
DescriptionProASICPLUS® Flash Family FPGAs
APA1000-PQG208ES Datasheet PDF : 178 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
ProASICPLUS Flash Family FPGAs
The TAP controller receives two control inputs (TMS and
TCK) and generates control and clock signals for the rest
of the test logic architecture. On power-up, the TAP
controller enters the Test-Logic-Reset state. To guarantee
a reset of the controller from any of the possible states,
TMS must remain high for five TCK cycles. The TRST pin
may also be used to asynchronously place the TAP
controller in the Test-Logic-Reset state.
ProASICPLUS devices support three types of test data
registers: bypass, device identification, and boundary
scan. The bypass register is selected when no other
register needs to be accessed in a device. This speeds up
test data transfer to other devices in a test data path.
The 32-bit device identification register is a shift register
with four fields (lowest significant byte (LSB), ID number,
part number and version). The boundary-scan register
observes and controls the state of each I/O pin.
Each I/O cell has three boundary-scan register cells, each
with a serial-in, serial-out, parallel-in, and parallel-out
pin. The serial pins are used to serially connect all the
boundary-scan register cells in a device into a boundary-
scan register chain, which starts at the TDI pin and ends
at the TDO pin. The parallel ports are connected to the
internal core logic tile and the input, output, and control
ports of an I/O buffer to capture and load data into the
register to control or observe the logic state of each I/O.
1
Test-Logic
Reset
0
0
Run-Test/
1
Idle
Select-DR-
1
Scan
0
Select-IR-
1
Scan
0
1
Capture-DR
1
Capture-IR
0
0
0
Shift-DR
0
Shift-IR
1
1
Exit-DR 1
Exit-IR 1
0
0
Pause-DR
0
0
Pause-IR
1
0 Exit2-DR
1
1
0
Exit2-IR
1
Update-DR
1
0
Update-IR
1
0
Figure 2-10 • TAP Controller State Diagram
v5.9
2-9
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]