MAX1247AEPE(1997) View Datasheet(PDF) - Maxim Integrated

Part Name

Description

Manufacturer

MAX1247AEPE
(Rev.:1997)

+2.7V, Low-Power, 4-Channel, Serial 12-Bit ADCs in QSOP-16

Maxim Integrated 

+2.7V, Low-Power, 4-Channel,

Serial 12-Bit ADCs in QSOP-16

COMPLETE CONVERSION SEQUENCE

DIN 1

00

FULLPD

(ZEROS)

9ms WAIT

1

01

FASTPD

CH1

1

11

NOPD

REFADJ

1.21V

0V

2.50V

VREF

0V

τ = RC = 20kΩ x CREFADJ

tBUFFEN ≈ 200µs

Figure 14. MAX1246 FULLPD/FASTPD Power-Up Sequence

CH7

1

00

FULLPD

(ZEROS)

1

01

FASTPD

Lowest Power at Higher Throughputs

Figure 13b shows the power consumption with

external-reference compensation in fast power-down,

with one and four channels converted. The external

4.7µF compensation requires a 200µs wait after

power-up with one dummy conversion. This circuit

combines fast multi-channel conversion with the lowest

power consumption possible. Full power-down mode

may provide increased power savings in applications

where the MAX1246/MAX1247 are inactive for long

periods of time, but where intermittent bursts of

high-speed conversions are required.

Internal and External References

The MAX1246 can be used with an internal or external

reference voltage, whereas an external reference is

required for the MAX1247. An external reference can

be connected directly at VREF or at the REFADJ pin.

An internal buffer is designed to provide 2.5V at

VREF for both the MAX1246 and the MAX1247. The

MAX1246’s internally trimmed 1.21V reference is buf-

fered with a 2.06 gain. The MAX1247’s REFADJ pin is

also buffered with a 2.00 gain to scale an external 1.25V

reference at REFADJ to 2.5V at VREF.

Internal Reference (MAX1246)

The MAX1246’s full-scale range with the internal refer-

ence is 2.5V with unipolar inputs and ±1.25V with bipo-

lar inputs. The internal reference voltage is adjustable

to ±1.5% with the circuit in Figure 15.

External Reference

With both the MAX1246 and MAX1247, an external ref-

erence can be placed at either the input (REFADJ) or

the output (VREF) of the internal reference-buffer ampli-

fier. The REFADJ input impedance is typically 20kΩ for

the MAX1246, and higher than 100kΩ for the MAX1247.

+3.3V

24k

100k

510k

0.047µF

MAX1246

9 REFADJ

Figure 15. MAX1246 Reference-Adjust Circuit

Table 5. Software Power-Down

and Clock Mode

PD1

PD0

0

0

0

1

1

0

1

1

DEVICE MODE

Full Power-Down

Fast Power-Down

Internal Clock

External Clock

Table 6. Hard-Wired Power-Down

and Internal Clock Frequency

SHDN

STATE

1

Floating

0

DEVICE

MODE

Enabled

Enabled

Power-Down

REFERENCE

BUFFER

COMPENSATION

Internal

External

N/A

INTERNAL

CLOCK

FREQUENCY

225kHz

1.8MHz

N/A

18 ______________________________________________________________________________________

Share Link: