Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

AD9520-4 データシートの表示(PDF) - Analog Devices

部品番号コンポーネント説明メーカー
AD9520-4 12 LVPECL/24 CMOS Output Clock Generator with Integrated 1.6 GHz VCO ADI
Analog Devices ADI
AD9520-4 Datasheet PDF : 84 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
AD9520-4
PD, SYNC, AND RESET PINS
Table 15.
Parameter
Min Typ Max Unit Test Conditions/Comments
INPUT CHARACTERISTICS
These pins each have a 30 kΩ internal pull-up resistor
Logic 1 Voltage
2.0
V
Logic 0 Voltage
0.8 V
Logic 1 Current
1 μA
Logic 0 Current
−110
μA The minus sign indicates that current is flowing out of
the AD9520, which is due to the internal pull-up resistor
Capacitance
2
pF
RESET TIMING
Pulse Width Low
50
ns
RESET Inactive to Start of Register Programming 100
ns
SYNC TIMING
Pulse Width Low
1.3
ns High speed clock is CLK input signal
SERIAL PORT SETUP PINS: SP1, SP0
Table 16.
Parameter
SP1, SP0
Logic Level 0
Logic Level ½
Min
0.4 × VS
Typ Max
0.25 × VS
0.65 × VS
Logic Level 1 0.8 × VS
Unit Test Conditions/Comments
These pins do not have internal pull-up/pull-down resistors
V
VS is the voltage on the VS pin
V
User can float these pins to get Logic Level ½; if floating this pin, user should
connect a capacitor to ground
V
LD, STATUS, REFMON PINS
Table 17.
Parameter
Min Typ Max Unit Test Conditions/Comments
OUTPUT CHARACTERISTICS
When selected as a digital output (CMOS); there are other
modes in which these pins are not CMOS digital outputs;
see Table 53, 0x017, 0x01A, and 0x01B
Output Voltage High, VOH
2.7
V
Output Voltage Low, VOL
0.4 V
MAXIMUM TOGGLE RATE
100
MHz Applies when mux is set to any divider or counter output,
or PFD up/down pulse; also applies in analog lock detect
mode; usually debug mode only; beware that spurs can
couple to output when any of these pins are toggling
ANALOG LOCK DETECT
Capacitance
3
pF On-chip capacitance; used to calculate RC time constant
for analog lock detect readback; use a pull-up resistor
REF1, REF2, AND VCO FREQUENCY STATUS MONITOR
Normal Range
1.02
MHz Frequency above which the monitor indicates the
presence of the reference
Extended Range
8
kHz Frequency above which the monitor indicates the
presence of the reference
LD PIN COMPARATOR
Trip Point
1.6
V
Hysteresis
260
mV
Rev. 0 | Page 15 of 84
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]