Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits
부품명  

AD8032ANZ 데이터 시트보기 (PDF) - Analog Devices

부품명AD8032ANZ ADI
Analog Devices ADI
상세내역2.7 V, 800 μA, 80 MHz Rail-to-Rail I/O Amplifiers
AD8032ANZ Datasheet PDF : 20 Pages
First Prev 11 12 13 14 15 16 17 18 19 20
AD8031/AD8032
OUTPUT STAGE, OPEN-LOOP GAIN AND
DISTORTION vs. CLEARANCE FROM POWER
SUPPLY
The AD8031 features a rail-to-rail output stage. The output
transistors operate as common-emitter amplifiers, providing the
output drive current as well as a large portion of the amplifier’s
open-loop gain.
DIFFERENTIAL
DRIVE
FROM
INPUT STAGE
I1
25µA
Q42
Q51
I2
25µA
Q47
Q37 Q38
Q20
R29
300
Q21
Q43 Q48
Q68
C9
5pF
Q27
C5
1.5pF
VOUT
I4
25µA
Q49
I5
25µA
Q50
Q44
Figure 44. Output Stage Simplified Schematic
The output voltage limit depends on how much current the
output transistors are required to source or sink. For applications
with low drive requirements (for instance, a unity gain follower
driving another amplifier input), the AD8031 typically swings
within 20 mV of either voltage supply. As the required current
load increases, the saturation output voltage increases linearly as
ILOAD × RC
where:
ILOAD is the required load current.
RC is the output transistor collector resistance.
For the AD8031, the collector resistances for both output
transistors are typically 25 Ω. As the current load exceeds the
rated output current of 15 mA, the amount of base drive current
required to drive the output transistor into saturation reaches its
limit, and the amplifier’s output swing rapidly decreases.
The open-loop gain of the AD8031 decreases approximately
linearly with load resistance and depends on the output voltage.
Open-loop gain stays constant to within 250 mV of the positive
power supply, 150 mV of the negative power supply, and then
decreases as the output transistors are driven further into
saturation.
The distortion performance of the AD8031/AD8032 amplifiers
differs from conventional amplifiers. Typically, the distortion
performance of the amplifier degrades as the output voltage
amplitude increases.
Used as a unity gain follower, the output of the AD8031/
AD8032 exhibits more distortion in the peak output voltage
region around VCC − 0.7 V. This unusual distortion characteristic is
caused by the input stage architecture and is discussed in detail
in the Input Stage Operation section,
OUTPUT OVERDRIVE RECOVERY
Output overdrive of an amplifier occurs when the amplifier
attempts to drive the output voltage to a level outside its normal
range. After the overdrive condition is removed, the amplifier
must recover to normal operation in a reasonable amount of
time. As shown in Figure 45, the AD8031/AD8032 recover
within 100 ns from negative overdrive and within 80 ns from
positive overdrive.
RF = RG = 2k
RG
RF
VIN
RL
50
VOUT
VS = ±2.5V
VIN = ±2.5V
1V RL = 1kTO GND
100ns
Figure 45. Overdrive Recovery
Rev. C | Page 14 of 20
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]