Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

ACPL-P341 查看數據表(PDF) - Avago Technologies

零件编号产品描述 (功能)生产厂家
ACPL-P341 3.0 Amp Output Current IGBT Gate Drive Optocoupler with Rail-to-Rail Output Voltage in Stretched SO6 Avagotech
Avago Technologies Avagotech
ACPL-P341 Datasheet PDF : 19 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Notes:
1. Derate linearly above 70° C free-air temperature at a rate of 0.3 mA/°C.
2. Maximum pulse width = 10 s. This value is intended to allow for component tolerances for designs with IO peak minimum = 2.5 A. See applications
section for additional details on limiting IOH peak.
3. Derate linearly above 85° C free-air temperature at a rate of 16.9 mW/°C.
4. Derate linearly above 85° C free-air temperature at a rate of 15.3 mW/°C. The maximum LED junction temperature should not exceed 125° C.
5. Maximum pulse width = 50 s.
6. Output is sourced at -2.5 A with a maximum pulse width = 10 s. VCC-VO is measured to ensure 15 V or below.
7. Output is sourced at 2.5 A with a maximum pulse width = 10 s. VO-VEE is measured to ensure 15 V or below.
8. Output is sourced at -2.5 A/2.5 A with a maximum pulse width = 10 s.
9. In this test VOH is measured with a dc load current. When driving capacitive loads, VOH will approach VCC as IOH approaches zero amps.
10. Maximum pulse width = 1 ms.
11. Pulse Width Distortion (PWD) is defined as |tPHL-tPLH| for any given device.
12. The difference between tPHL and tPLH between any two ACPL-P341 parts under the same test condition.
13. Pin 2 needs to be connected to LED common.
14. Common mode transient immunity in the high state is the maximum tolerable dVCM/dt of the common mode pulse, VCM, to assure that the
output will remain in the high state (i.e., VO > 15.0 V).
15. Common mode transient immunity in a low state is the maximum tolerable dVCM/dt of the common mode pulse, VCM, to assure that the output
will remain in a low state (i.e., VO < 1.0 V).
16. In accordance with UL1577, each optocoupler is proof tested by applying an insulation test voltage ≤ 4500 VRMS for 1 second (leakage detection
current limit, II-O < 5 A).
17. In accordance with UL1577, each optocoupler is proof tested by applying an insulation test voltage ≤ 6000 VRMS for 1 second (leakage detection
current limit, II-O < 5 A).
18. Device considered a two-terminal device: pins 1, 2, and 3 shorted together and pins 4, 5 and 6 shorted together.
19. The device was mounted on a high conductivity test board as per JEDEC 51-7.
8
Direct download click here

 

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2019  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]