M1A3P400-1PQG208YPP View Datasheet(PDF) - Microsemi Corporation

Part Name

Description

Manufacturer

M1A3P400-1PQG208YPP

(A3Pxxx) ProASIC3 Flash Family FPGAs with Optional Soft ARM Support

Microsemi Corporation 

Revision

v2.0

(April 2007)

ProASIC3 Flash Family FPGAs

Changes

In the "Packaging Tables", Ambient was deleted.

Page

ii

The timing characteristics tables were updated.

N/A

The "PLL Macro" section was updated to add information on the VCO and PLL

outputs during power-up.

2-15

The "PLL Macro" section was updated to include power-up information.

2-15

Table 2-11 • ProASIC3 CCC/PLL Specification was updated.

2-29

Figure 2-19 • Peak-to-Peak Jitter Definition is new.

2-18

The "SRAM and FIFO" section was updated with operation and timing

requirement information.

2-21

The "RESET" section was updated with read and write information.

2-25

The "RESET" section was updated with read and write information.

2-25

The "Introduction" in the "Advanced I/Os" section was updated to include

information on input and output buffers being disabled.

2-28

PCI-X 3.3 V was added to Table 2-11 • VCCI Voltages and Compatible

Standards.

2-29

In the Table 2-15 • Levels of Hot-Swap Support, the ProASIC3 compliance

descriptions were updated for levels 3 and 4.

2-34

Table 2-43 • I/O Hot-Swap and 5 V Input Tolerance Capabilities in ProASIC3

Devices was updated.

2-64

Notes 3, 4, and 5 were added to Table 2-17 • Comparison Table for 5 V–

Compliant Receiver Scheme. 5 x 52.72 was changed to 52.7 and the Maximum

current was updated from 4 x 52.7 to 5 x 52.7.

2-40

The "VCCPLF PLL Supply Voltage" section was updated.

2-50

The "VPUMP Programming Supply Voltage" section was updated.

2-50

The "GL Globals" section was updated to include information about direct input

into quadrant clocks.

2-51

VJTAG was deleted from the "TCK Test Clock" section.

In Table 2-22 • Recommended Tie-Off Values for the TCK and TRST Pins, TSK

was changed to TCK in note 2. Note 3 was also updated.

2-51

2-51

Ambient was deleted from Table 3-2 • Recommended Operating Conditions. 3-2

VPUMP programming mode was changed from "3.0 to 3.6" to "3.15 to 3.45".

Note 3 is new in Table 3-4 • Overshoot and Undershoot Limits (as measured on 3-2

quiet I/Os)1.

In EQ 3-2, 150 was changed to 110 and the result changed from 3.9 to 1.951.

3-5

Table 3-6 • Temperature and Voltage Derating Factors for Timing Delays was 3-6

updated.

Table 3-5 • Package Thermal Resistivities was updated.

3-5

Table 3-14 • Summary of Maximum and Minimum DC Input and Output Levels 3-17 to 3-

Applicable to Commercial and Industrial Conditions—Software Default Settings 17

(Advanced) and Table 3-17 • Summary of Maximum and Minimum DC Input

Levels Applicable to Commercial and Industrial Conditions (Standard Plus) were

updated.

Revision 13

5-7

Share Link: