A10V10B-1CQ44I View Datasheet(PDF) - Actel Corporation
Part Name
Description
Manufacturer
A10V10B-1CQ44I Datasheet PDF : 24 Pages
| |||
ACT™ 1 Series FPGAs
Functional Timing Tests
AC timing for logic module internal delays is determined
after place and route. The DirectTime Analyzer utility
displays actual timing parameters for circuit delays. ACT 1
devices are AC tested to a “binning” circuit specification.
The circuit consists of one input buffer + n logic modules +
one output buffer (n = 16 for A1010B; n = 28 for A1020B). The
logic modules are distributed along two sides of the device, as
inverting or non-inverting buffers. The modules are
connected through programmed antifuses with typical
capacitive loading.
Propagation delay [tPD = (tPLH + tPHL)/2] is tested to the
following AC test specifications.
Output Buffer Performance Derating (5V)
Sink
12
Source
–4
10
–6
8
–8
6
–10
4
0.2
0.3
0.4
0.5 0.6
–12
4.0 3.6 3.2 2.8 2.4 2.0
VOL (Volts)
VOH (Volts)
Military, worst-case values at 125°C, 4.5 V.
Commercial, worst-case values at 70°C, 4.75 V.
Note: The above curves are based on characterizations of sample devices and are not completely tested on all devices.
Output Buffer Performance Derating (3.3V)
Sink
12
Source
–4
10
–6
8
–8
6
–10
4
0.0
0.1
0.2
0.3 0.4
–12
0
0.5 1.0 1.5 2.0 2.5
VOL (Volts)
VOH (Volts)
Commercial, worst-case values at 70°C, 4.75 V.
Note: The above curves are based on characterizations of sample devices and are not completely tested on all devices.
1-291
|
|
Share Link: 